AMERICANA RT3 User manual

RT3 OUTDOOR SHADE CURTAIN
INSTALLATION INSTRUCTIONS
STEP 1
ASSEMBLY COMPLETED
STEP 2
ph. [phone]
eb .americana.com
Fig. 1-1 Fig. 2-1
Locate all studs and position Wall Brackets. Attach Wall Brackets to all. Note: Scre s must hit solid ood. Do Not attach
to sheeting, siding, flashing, or any other non-structural surface. When marking the location of the a ning, please note the
crank/motor ill overhang 2 1/2" to the side of the fabric and the opposite side ill overhang 1". The fabric idth is 5" less
than the Wall Bracket idth.
Once the Wall Brackets are mounted and level, insert the end of the Roller Bar opposite the crank/motor in the Bushing,
then in a Mounting Bracket. Next, slide the Roller Bar bet een the brackets and, using 2 allen head bolts, fasten the
motor/crank to the other bracket. (see Fig. 2-1)
Keep Brackets Square and Level
Bushing
Roller Bar and Fabric
Mounting Bracket
Motor/Crank
Mounting Bracket

RT3 OUTDOOR SHADE CURTAIN
INSTALLATION INSTRUCTIONS
OPTIONAL GUIDE CABLE INSTALLATION
ph. [phone]
we www.americana.com
Fig. GC-1
Fig. GC-3
Fig. GC-2
-To mount the optional guide ca les, leave the curtain unrolled at the desired length. Mount (2) ca le rackets slightly elow
the weight tu e using (2) 1-1/4" phillips head lag screws, (1) per racket (see Fig. GC-1).
-Mount the remaing ca le rackets slightly elow the roller ar and in line with the ottom rackets. See Fig. GC-2.
-Feed the guide ca le through the upper ca le racket. Pull the ca le all the way through until the stop at the end hits the
racket. Feed the ca le through the eye of the weight tu e at the ottom of the curtain and through the lower ca le racket.
-Keep the guide ca le straight and tighten the set screw in the ca le rackets using a 3mm hex key. Cut off excess ca le.
Ca le Bracket
1-1/4" Phillips
Flat Head Lag Screw
Weight
Tu e
Curtain
Tighten Set Screw
Weight Tu e Guide
Stop
Upper Ca le Bracket
Lower Ca le Bracket