Attach seat (A) to legs (C & D) using 4 1/4” x 1
3/4”
wafer bolts (AA) underneath seat.
Assembly Instructions
Classic 2ft Glider
AC30
A
D C
E
G
H
F
B
PARTS
12
3 4
Grab the seat back (B) and place towards the back of the seat
assembly (step 1). Install 2 1/4” x 1
3/4” wafer bolts (AA) on the
inside back of the seat back at arms. Install 4 5/16” x 3”wafer
bolts (BB) on the inside bottom of the seat back.
Lift chair assembly from step 2 over base assembly from step 3. Attach chair
to base working from the outside in: Insert a 5/16” x 3” wafer bolt (BB)
through leg, place washer on bolt end, thread through metal support on base,
finish with a lock nut. Repeat for each of the 4 corners of the chair.
Attach pieces E & F to the glider bases
G & H using 12 3” screws, 3 on each
side of E & F We hope you enjoy your new piece of furniture for years to come!
A
D
E
B
C
AA
CC
CC
AA
BB
HARDWARE
TOOLS
1/4” x 1
3/4” Wafer Bolt
5/16” Washer 5/16” Lock Nut
5/16” x 3”Wafer Bolt
3”Screws
AA
BB
CC
DD EE
x6
x4 x4
x8
x 12
Note before starting: wait until the whole piece is assembled to tighten the bolts.
FG
H
BB DD
EE
Hex Key
Screwdriver
(not provided)
Wrench
