Andrew ValuLine User manual

2
3
to antenna
hand tighten nuts
INSTALLATION
DURING MOUNT
PROTECTIVE CAP
DO NOT REMOVE
evenly and torque
nuts (4) to
22Nm (16.2lb-ft)
to a vertical pipe of diameter 48-115mm
(1.9-4.5").
The mount also provides adjustment in the
ranges of ±25°fine elevation and
±180°(±10°fine) azimuth.
experienced personnel Andrew installation
practices.
unsafe installation
responsibility for the results of improper or
Andrew disclaims any liability or
maintenance and condition of equipment.
personnel to verify proper installation,
inspected once a year by qualified
personnel. antenna systems should be
instructions have been written for such
Notice
The installation, maintenance, or removal of
antenna systems requires qualified,
Description
This antenna consists of a 0.2-metre(20cm)/
0.3-metre (1ft)/ 0.6-metre (2ft) reflector,
radome, feed and offset tower mount.
The mount is designed to attach the antenna
When fitting
Apply loctite (8)
to threads
before fitting
56
7*
7* 4
10
10
Visit our Web site at www.andrew.com or contact your local Andrew Wireless Solutions representative for more information.
102222
03
Bulletin
Version Rev EREStatus
1
2
102222
BRE01
Bulletin
RevStatusModel Version
Version RevStatus
0.2m(20cm), 0.3m(1ft) & 0.6m(2ft)
ValuLine Antenna Mount
1 of 2page
Installation Instructions A CommScope Company
GRE
03
Andrew Institute offers installation training.
Andrew Wireless Solutions
© 2008 CommScope, Inc. All rights reserved.
Andrew Wireless Solutions is a trademark of CommScope. All trademarks identified by® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement any
Other Europe: [phone]
U.K.: 0800 250055
or 1-888-235-5732
U.S.A., Canada, Mexico: 1-800-255-1479
Customer Service 24 hours
specifications or warranties relating to Andrew Wireless Solutions products or services.
www.andrew.com
Notice: Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: Andrews no acepta ninguna obligacion ni responsabilidad como resultado de practicas incorrectas o peligrosas de instalacion, inspecci6n, mantenimiento o retire.
Avis : Andrew decline toute responsabilite pour les consequences de procedures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: Andrew lehnt jede Haftung Oder Verantwortung fur Schaden ab, die aufgrund unsachgemaBer Installation, Uberprufung, Wartung Oder Demontage auftreten.
Atencao: A Andrew abdica do direito de toda responsabilidade pelos resultados de praticas inadequadas e sem seguranca de instalacao, inspecao, manutengao ou remocao.
Awertenza: Andrew declina eventual! responsabilita denvanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
2
1
0.3m (1ft) Application
(Single Pole version shown)

mount Kit (item 2)
* Part of Pre-assembled
(item 7- Protective Caps)
Rotate to adjust Azimuth
DO NOT REMOVE
Azimuth (top & bottom)
Slacken bolts 1/2 turn to adjust elevation
Rotate to adjust
to adjust Elevation
slacken bolts 1/2 turn
1*
Table 1 Antenna Parts list
Item Description Qty
1 1ft or 2ft Reflector Assembly 1
2 Pre-Assembled Mount Kit 1
3 M10x35 c'sk skt hd screw, SS 3*
4 M10 Nut 4*
5 M10 Lockwasher 4*
6 M10 Flatwasher 4*
7 Protective Cap 4*
8 Loctite, tube 1/2ml 1*
9 Allen key fo M10 c'sk screws 1*
10 Conductive grease, tube
Table 2. Fastener Torque Specifications
Torque Values in Nm (lb.ft) for
each fastener
Fastener
Size M5 M6 M8 M10 M12 16
Stainless
Steel 4.5 (3.3) 7.7 (5.7) 18.7 (13.8) 39.2 (28.9) 65.1 (48) 161 (118.7)
Galvanised
Steel 2.7 (2) 4.5 (3.3) 11.1 (8.1) 22 (16.2) 38 (28) 95 (70.1)
Antenna
offset Left
0.2m(20cm), 0.3m(1ft) & 0.6m(6ft) 102222
BRE01
Bulletin
RevStatusModel Version
Version RevStatus
2 of 2page
Installation Instructions A CommScope Company
GRE
03
Andrew Institute offers installation training.
Andrew Wireless Solutions
Awertenza: Andrew declina eventual! responsabilita denvanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
Visit our Web site at www.andrew.com or contact your local Andrew Wireless Solutions representative for more information.
© 2008 CommScope, Inc. All rights reserved.
Andrew Wireless Solutions is a trademark of CommScope. All trademarks identified by
Other Europe: [phone]
U.K.: 0800 250055
or 1-888-235-5732
U.S.A., Canada, Mexico: 1-800-255-1479
Customer Service 24 hours ® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement any
specifications or warranties relating to Andrew Wireless Solutions products or services.
www.andrew.com
Notice: Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: Andrews no acepta ninguna obligacion ni responsabilidad como resultado de practicas incorrectas o peligrosas de instalacion, inspecci6n, mantenimiento o retire.
Avis : Andrew decline toute responsabilite pour les consequences de procedures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: Andrew lehnt jede Haftung Oder Verantwortung fur Schaden ab, die aufgrund unsachgemaBer Installation, Uberprufung, Wartung Oder Demontage auftreten.
Atencao: A Andrew abdica do direito de toda responsabilidade pelos resultados de praticas inadequadas e sem seguranca de instalacao, inspecao, manutengao ou remocao.
ValuLine Antenna Mount
Dispose of empty or partially filled containers according to
governmental regualtions for petroleum products
contents: oil, clay and zinc dust.
rinse with water. Do not store open near food sources.
offset Right
Antenna
Warning: use protective wear to avoid skin contact with the
pre-applied conductive grease on threads. Keep away from mouth.
Wash throughly after use with liberal amounts of liquid soap and
!