AndyMark Robot Competition Table User manual

4X - Flat Head Screw
Bottom View
Table Setup & Disassembly
1. Slide each section together. Ensure the dowel pins in each outer section t into the holes on the center section.
The latches will be closest to the north side of the table.
2. Secure sections together using 4X Flat Head Screws. These screws will t in the countersunk holes on the four
corners of the inner panel.
For more information visit AndyMark.com/Table
W
E
N
S
The AndyMark Robot Competition table can split into 3 sections for
transportation and storage.
Required Tools
#2 Phillips Screwdriver
Section Assembly

For more information visit AndyMark.com/Table
Practice and Tournament Setup
For Practice, the table can be placed by itself on the oor or on a table or sawhorses to elevate it’s height. Ensure
the weight of each section is supported underneath and the table is positioned so that it cannot easily fall or be
tipped.
For Tournament Play, two tables can be placed with their North walls touching and secured together with the
latches on the East and West walls.
Storage and Transportation
The table is designed to be split into 3 sections for storage and transportation by removing the 4 Flat Head Screws
and separating the sections. The Flat Head Screws can be re-threaded into the brackets to ensure they don’t get
lost.
To prevent damage and table warping, store in a dry environment free from extreme temperature changes.