flammable materials, e.g., gasoline, etc.). If a flame appears for any reason, place the device on a horizontal fireproof
surface without pressing the bellow. To extinguish the flame faster, cover the nozzle (e.g., with wet paper or cloth). The
device will put itself out in 5-30 minutes.
Avoid bringing metal into contact with the battery or charger terminals. You will cause irreparable damage to the
charger, and you may destroy the batteries.
The vapor-smoke residues are very hot and can cause burns or a fire when they come into contact with flammable
materials. Avoid any contact with body parts or flammable materials until they have cooled down.
Use suitable batteries only. Batteries with different characteristics may destroy the resistance, the circuits, and the
device and/or exceed temperature safety levels resulting in a flame or fire. Smaller batteries will produce insignificant
or no smoke.
When in operation, the resistance is extremely sensitive. Do not apply powerful force as you will damage it.
The resistance reaches high temperatures and there is the risk of severe burns; therefore, avoid any contact with body
parts or flammable materials when it is hot.
If you notice bare - damaged wires in the circuit of the charger or device, do not use them and return them for repair to
the reseller, or to ANEL.
Always use the suitable chargers with the appropriate adapters. Unsuitable chargers may destroy your battery or not
charge properly.
In the event that you have followed the preparation instructions (battery charging and testing, resistance operation),
but vapor-smoke is not produced, contact the ANEL’s technical support department or your reseller.
The device is not waterproof; it is not allowed to come into contact with water. If it gets wet, blow with compressed air
in all places, open the fuse box, remove the fuse, and blow there too. Operate the device again only when you are
absolutely sure that all its parts are dry. There is danger of a short circuit.
The device, batteries and charger are not manufactured to withstand falls and collisions. A fall or collision may destroy
parts or all the device and accessories, therefore handle it with care.
If a problem arose from a fall or collision to the device, batteries, or the charger.
Batteries are attached to the device with a Velcro strap. If the Velcro is damaged or worn, the battery may not secure
well and detach from the device and hang from the adapter, thus establishing the device unsafe. If the Velcro of the
battery casing is worn, contact the reseller or ANEL for a new one.
The device has points that may injure you if you use it with bare hands. Always use beekeeping gloves when handling
the device.
The batteries must be charged in a controlled environment because the event of material failure, over voltage, etc.;
there is a risk of self-ignition and fire and the risk of burning materials being displaced. When charging these batteries
place them on a fireproof surface.
Safety information
To prevent any injury to yourself or others and to not damage your device, read the information that follows before
using the device.
Warning: Prevent electric shock, fire, and explosion.
Do not use power cable or adapters that are damaged, or loose electrical sockets.
Do not touch power cables with wet hands and do not disconnect the charger by pulling the cord.
Do not bend or damage the power cable. Do not short circuit the charger or battery.
Do not expose the charger or battery to falls or collisions.
Do not charge the battery with chargers that have not been approved by the manufacturer.
Do not use your device while it is charging and do not touch your device with wet hands.
Do not use your device during a thunderstorm.
The device may malfunction and there is a high risk of electric shock.
Do not use a Lithium Ion (Li-Ion) battery that has been damaged or is leaking.
To safely discard lithium-ion batteries, contact the closest authorized repair center.
Use and discard batteries and chargers with caution.
