anko H1103B User manual

Humidifier
Model: H1103B
User Manual
PLEASE READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE

2
3
IMPORTANT SAFETY
INSTRUCTIONS:
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
WHEN USING
ELECTICAL PRODUCTS.
READ AND SAVE THESE INSTRUCTIONS
• Always place humidifier on a firm, flat surface. A waterproof mat or pad
isrecommended for use under the humidifier. Never place it on a rug or
carpet, or on a finished floor that may be damaged by exposure to water
or moisture.
• Always unplug the unit from the electrical outlet immediately after using
and before cleaning.
• DO NOT place or store the unit where it can fall or be pulled into a tub or
sink.
• DO NOT place or drop into water or other liquids.
• DO NOT use water above 30°C.
• Use this unit only for its intended use as described in this manual. Do
not use attachments not recommended by Kmart; specifically any
attachments not provided with this unit.
• NEVER drop or insert any object into any opening.
• Always hold the water tank firmly with both hands when carrying a full tank
of water.
• DONOT place the humidifier near heat sources, such as a stove, and do
not expose the humidifier to direct sunlight.
• DO NOT carry this unit by the power cord or use the power cord as a
handle.
• This unit is designed for personal, non-professional use only.
• DO NOT use outdoors. For indoor use only.
• This appliance is not intended for use by persons (including children)
withreducedphysical,sensoryormentalcapabilities,orlackof
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.

2
3
• Never cover the unit while it is operating.
• Always keep the cord away from high temperature and fire.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order toavoid a hazard.
• Do not attempt to adjust or repair the unit. Servicing must be
performed by professional or qualifiedpersonnel.
• Stop using this unit if there is an unusual noise or smell.
• Unplug this unit when not in use for a long period of time.
• Do not touch the water or any parts of the unit that are covered by
water while the unit is on or plugged in.
• Unplug the appliance during filling and cleaning.
About White Dust:
Use of high mineral content hard water may cause a white mineral residue
to accumulate on surfaces in the room near the humidifier. The mineral
residue is commonly called “white dust.” The higher the mineral content (or,
the harder your water is), the greater the potential for white dust. The white
dust is not caused by a defect in the humidifier. It is caused only by minerals
suspended in the water.

4
5
Unique Features and Specifications
Ultrasonic Technology
This humidifier uses ultrasonic high frequency technology to convert the water into
1–5 million super particles that are dispersed into the air evenly.
Warm & Cool Mist Function
Choose either warm or cool mist for customized comfort.
In winter, a more draught weather was expected. Warm mist function can release
mist around 35 ℃ which helps to make the air relatively warmer, a greater comfort to
user,especiallythosesufferedfromirritatedsinuses.Besides,by usingthe warm
mist mode, mist output can be 20-30% more than cool mist.
Night Light
A useful night light feature is included for your convenience.
Built-in Timer
Programmable timer, up to 12 hours
Auto Shut-Off Protection
When the tank is empty the unit will shut off automatically.
Voltage
Watts
Capacity
230-240V
55-62W
5.6 liters
Run Time: Up to 65 hours
Runtime is calculated based on using cool water and setting the mist level tothe
low setting. Based on the natural humidity level inyour home, thetemperature of
water you use, and the mist level setting you choose, you may experience longer or
shorter run times.
Warm & Cool Mist Ultrasonic Humidifier
Mist Spout
Control Panel
Aromatherapy housing
Fig.1

6
7
Fig. 3
How To Use
NOTE:
• To disconnect, touch power
button controls to the “off”
position, then remove the plug
from the outlet.
• Never operate without water
in the tank.
• Only use water in the tank.
• Never use any additive to the
water.
• Do not wash, adjust, or
move this unit without first
unplugging it from the
electrical outlet.
Timer Function
PresstheTIMERbuttontoactivatethetimer. Thetimerwillcyclethroughthe following
settings 0 (OFF) -1 hours- 2 hours- 3 hours- 4 hours-5 hours- 6 hours- 7 hours- 8 hours- 9
hours- 10 hours-11 hours- 12hours-OFF.
Night Light Function
PresstheLIGHTbuttononcetoturnonthenightlight.Thelightatthebottomofthewatertank will
turnon,illuminatingthetank.PresstheLIGHT button asecond timetoleavethenightlight on, but
the brightness of lights will decrease. Press the LIGHT button a third time to turn off night light
(Note: LCD and LEDs under control panel will off at the same time). Press the LIGHT buttona
fourthtime, LCDandLEDsundercontrolpanelwill switch ON and night light will be OFF.
Warm Mist Function
Press the WARM button once to turn on the warm mist, the red indicator at the top of WARM
buttonwillturnon.PresstheWARMbuttona secondtimetoturnoffthewarmmist,thered
indicator will turn off.
Aromatherapy function
Power Function
Plug unit in to a 220-240VAC electrical outlet. Press the POWER button to turn unit on. Press the
POWER button again to turn unit off.
ATTENTION: w hen you press ON the humidifier, but the water tank is empty, the 3 icon display
flash10times to indicate water isempty.
Programmable Humidistat Function
This unit has a Programmable Humidistat that can be set in 5% increments from 30%-75%
humidity. Keep pressing the HUMIDISTAT button until the desired humidity level setting is
reached. The LCD display will show the set humidity level for 3 seconds, then will default
back to display the current humidity. (if display showing "--" means humidity is one
level above 75% or one level below 30%).
When the humidifier is first powered ON (connected to mains and switched ON), it will take
10stodetect the ambient humidity, and if the ambient humidity is higher than user setting, it will
stop working. When the humidifier is in operation and the ambient humidity is lower than
2% of the user setting, the humidifier will continue to function On and OFF to maintain
the set humidity setting.
Mist Output Setting Function
Press the MIST button to activate the mist output setting. The mist output setting will cycle through
the following settings 1(Low)-2(Ideal)-3(High).
You can add essential oil of your choice, take out tray from unit (Fig 3.), add 1~2drops essential
oil on to the pad, then put back the tray onto unit. There is one pad in the tray and two pads in the
accessory bag.
ATTENTION: Do not add two much essential oil ontothepad(notmorethan1or2drops).Toomuchessential oil
can leak into the unit when the tray is installed, this can damage the unit.
Fig. 2
Warm Mist Function
Night Light Function
Timer Function
Programmable
Humidistat Function
Power Function
Mist Output Setting
Function

8
9
How to Fill
CAUTION:Beforefillingunitwithwater,turnthepower off and unplugunitfrom mains
power outlet.
NOTE: Always use two hands to carry the water tank.
1. Grasp tank handle and lift up from humidifier base.
(Fig.4)
2. Turn the tank upside down—remove the tank cap
by turning it counter-clockwise. (Fig. 5)
3. Fill the water tank with clean, cool water. We
recommend using distilled water if you live in a hard
water area. (Fig. 6)
IMPORTANT! DO NOT add essential oils to water
tank. Even a few drops can ruin the humidifier.
4. Replace the tank cap by turning clockwise until
tight. (Fig. 7)
5. Install tank back on the base of the unit. Make sure
the tank is firmly seated. (Fig. 8)
NOTE: It is normal to have a small amount of water in
the base of the humidifier during and after use.
Cleaning and Care
CAUTION: Before cleaning the unit, turn power off and unplug unit from the outlet.
• Perform regular maintenance on the ultrasonic membrane.
• Never use detergent to clean the ultrasonic membrane.
• Never clean the ultrasonic membrane by scraping with a hard object.
To Clean the Tank
Remove the tank from the humidifier base by lifting it from
themain unit. Unscrew thetank capandrinse insidethetank
with clean water.
Toremoveanyscaleorbuild-up,usea50/50mixtureof
vinegar and lukewarm water to clean the inside of the tank.
(Fig. 9)
Suggestion: Clean the water tank once every two to
three weeks, depending on your water conditions.
To Clean the Ultrasonic Membrane
Pour a 50/50 mixture of vinegar and water on the surface of
theultrasonic membrane, then soak for five minutes. Brush
cleanwithasoft-bristlebrush(notincluded)andrinse.
NEVER touch the ultrasonic membrane with your fingers as
thenatural oils inskincan damagethemembrane.(Fig.10)
Suggestion: Clean the membrane once every two to
three weeks, depending on your water conditions.
NOTE: Never submerge the base in water or any liquid.
To Clean the Surface
Clean the surface of your humidifier with a clean,
damp, soft cloth as often as needed. (Fig. 11)
Fig. 9
Fig. 10
Fig. 11
Fig. 5
Fig. 6
Fig. 7
Fig. 4
Fig. 8

10
11
Troubleshooting 12 Month Warranty
Thank you for your purchase from Kmart.
KmartAustralia Ltdwarrantsyournewproductto befreefrom defects
inmaterials and workmanship for the period stated above, from the
date of purchase, provided that the product is used in accordance with
accompanying recommendations or instructions where provided. This
warranty is in addition to your rights under the Australian Consumer Law.
Kmartwillprovideyouwith yourchoiceofarefund,repair or exchange
(wherepossible)forthisproductifitbecomesdefectivewithinthe
warranty period. Kmart will bear the reasonable expense of claiming the
warranty. This warranty will no longer apply where the defect is a result
of alteration, accident, misuse, abuse or neglect.
Please retain your receipt as proof of purchase and contact our Customer
Service Centre on 1800 124 125 (Australia) or 0800 945 995 (New Zealand)
or alternatively, via Customer Help at Kmart.com.au for any difficulties
with your product. Warranty claims and claims for expense incurred in
returning this product can be addressed to our Customer Service Centre
at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund
for a major failure and compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
For New Zealand customers, this warranty is inaddition tostatutory
rights observed under New Zealand legislation.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Power Light is off/ No
mist from spout
• Unit is not plugged in
• No power at the mains
power outlet
• Low water level
• Timer function
• Plug unit in
• Press the POWER button
touch to turn the power on
• Check circuits and fuses or
try a different outlet
• Refill tank with water
• Timer function may have
been set and caused
the unit to turn off.
Peculiar Odor
• If new unit
• If unit is in use, the odour
may due to old water in
the tank.
• Open the water tank cap
and keep it in a shady and
cool place for 12 hours
• Empty the old water, clean
the tank and fill with clean
water
Excessive Noise
• Unit is notlevel
• Low waterlevel
• Place unit on a flat,even
surface
• Check the water level.
Refill the tank if the water
is low
• Remove vent cover and
brush or vacuum clean the
vent filter
WhiteDustAccumulation
• Tank needs refilling
• Use distilled water
• Clean the water tank clean
the water tank by brush