* Keep the appliance and mains cord away from sources of heat such as cooking plates or
open gas flames. This could cause melting.
* Keep the mains power cord away from sharp work surface or edges to prevent damage to the
power cord.
* Unplug the kettle from mains power, ...
... if an abnormality occurs during use,
... if you are not going to use it for a prolonged period,
... during thunderstorms and
... before cleaning it.
When doing so, always pull from the plug, not from the mains cord.
* Do not use the appliance if the kettle, base or mains cord show any visible sign of damage.
* Do not make any modifications to the appliance and its mains cord or change the connection
cable yourself.
Warning - risk of burns / scalding
*Always place the water kettle on a solid and even surface.
Ensure that it cannot slip or be dropped and that the power cord does not hang down.
* The kettle becomes hot while in use. Do not move the kettle during operation and do not pull
on the mains cord. Only hold/lift the hot kettle by its handle.
* Contact with rising steam can cause scalding! Make sure the lid is always firmly closed and
do not open it while water is boiling or while pouring water out.
* Do not fill the container with less than Min. (0.5L) or more than Max. (1.5L) of water.
If there is not enough water in the kettle, the appliance may overheat.
* Be sure that the kettle is switched OFF before taking it off the power base.
* The kettle is only to be used with the base provided.
* If the kettle is overfilled, boiling water may be ejected.
* CAUTION! The heating element and surfaces are subject to residual heat after use.
WARNING — Avoid water spillage on the electrical connectors.
*WARNING — Potential injury from misuse.
*WARNING — Do not remove the lid while the water is boiling.
IMPORTANT!
*Take care that any steam escaping from the appliance cannot damage wallpaper, wall
cabinets or other items. Turn the spout away from furniture and walls.
* Do not use caustic, aggressive or abrasive cleaning products for cleaning.
Keep hard items away from the appliance.
*Although the kettle is protected from boiling dry, it must never be operated without water.
* If the overheat cut-out switch switches OFF the kettle to prevent overheating and boiling dry,
proceed as follows:
- Take the kettle from the base.
- Allow the kettle to cool down for at least 15 minutes before refilling it with fresh water and
replacing the kettle back on the power base.
* Only use the kettle with the power base provided.
* Furniture today is often coated with a wide range of vamishes and plastics and is treated with
various protective substances. Some of these products may contain substances that react
adversely with the rubber feet on the power base, soften them and cause staining on the
surface. Therefore, we recommend placing a non-slip mat under the rubber feet on the kettle base.
--USE-
Unpacking
DANGER to children- danger to life due to suffocation/swallowing
Keep the packing material out of children's reach. Dispose of it immediately.
* Carefully remove all parts from the packaging and check that no parts are missing or possibly damaged.
* Remove all packaging material.
First time use
IMPORTANT! During the below process, DO NOT fill more than the Min. (0.5L) mark on the kettle.
Filling above the Min. (0.5L) mark will cause overboiling and spillage out of the spout.
To ensure a long service-life of the water kettle, proceed as follows before using it for the first
time:
1.
Fill the kettle with water and add vinegar in a ratio of 1:3 (1 part vinegar / 3 parts water).
Note: Make the mixture in a separate container and then pour into the kettle up to the Min. (0.5L) mark only.
2.
Bring to a boil (see Boiling water), then discard the water.
3.
Allow the kettle to cool down and then refill it fresh water. Boil the water and then pour it away.
To avoid scale deposits, descale the water kettle at regular intervals (after about every
15th use) as described in the section "Descaling".
Boiling water
WARNING: Risk of scalding from hot water
* The kettle and its lid become hot while in use. Do not touch.
* The lid must be tightly closed during the boiling process. It must not be opened while pouring
out water. Allow the appliance to cool down before opening the lid.
* Do not fill the water with less than MIN. (0.5L) or more than MAX. (1.5L) of water.
Lid release
1.
Press the lid release trigger.
trigger
The lid opens automatically.
2.
Fill the kettle with the amount of water required.
You can check the fill level on the markings on the kettle.
3.
Press the front of the lid down firmly to close it.
