anko 43024995 User manual
This CD Player adopts semiconductor unit,not including spare parts for users to replace.Don't take apart the machine by yourself toavoid electric shock. If the machine is damaged, please ask the qualified maintenance worker torepair. POWERPower of this player should be used correspondingto the information on the rating label.VENTILATION5cm minimum distances around the CD plyaer for sufficient ventilation.The function of air vent on the main case is to keep CD Player from overheating. Don't block or cover the air vent and put the player on the bed or sofa.The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.HEAT SOURCEThe machine should be kept away from heatsource, such as stoves and direct sunlight.NAKED FLAME SOURCEThe machine should be kept away from nakedflame sources, such as lighted candles should be not placed on themachine.WATER AND MOISTUREDon't use this machine in the humid environment,such as bathroom,kitchen, humid basement and so on.Caution:The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus. CLEANINGBefore cleaning, please put the power off first.Don't use liquid cleaners or corrosive fluid toclean the machine, just clean it by a soft cloth.POWERWhile inserting or pulling out power cord,gripthe plug not the wire.If do not use the machinefor a long time, please pull out power cord.To be completely disconnect the power input, the Radium LaserWhile the case is open and the CD Player is working, don't look at the laser directly with nakedeyes, otherwise, it will have a bad influence on the eyesight.DISCAvoid using the disc which is cracking, deformed or repaired, otherwise, the machine will appearmalfunction or shorten usage life.MALFUNCTION REQUIRINNG MAINTANENCEIf the following problems appear, please put off the power, and contact the qualified maintanence worker.A.The power cord or plug is damaged.B.Liquid or other foreign matters in the unit.C.The machine is caught in the rain or watered.D.While the machine can't work even accordingto the manual operation, don't press other buttomwhich aren't mentioned on the manual.Otherwise,it will cause the machine damaged and take themainantence worker more time to fix .E.The machine drops from high place.F.The inner part gives out a burnt smell.MaintanenceIf you arenot familiar with the maintanence technical skill of the machine, don't try to fix it byyourself.If you open the main case, you might beget electric shock.If needed, contact the qualifiedmaintanence worker.DISC TRAY DOORWhile closing the disc tray door, keep fingersaway from it to avoid being damaged.LOADING WEIGHTDon't put any heavy objects on the machine inorder to keep the machine from being damaged.CONNECTING OTHER EQUIPMENTSBefore connecting other equipments with theCD Player, make sure to put off the power.Otherwise, it will make equipments or usersdamaged.SAFETY INSPECTIONAfter maintanence, requesting maintanence worker to implement site safety inspection to make sure the machine works safely.NOTE:The use of apparatus in moderate climates.Please read the manual carefully before using the machine, and keep it well for using in thefuture.mains plug of machine shall be disconnected from the mains.The mains plug of machine should not be obstructed OR should be easily accessed during intended use.CAUTION !THIS PRODUCT UTILIZES A LASER. USE OF CONTROL OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.REFER SERVICING TO QUALIFIED PERSONNEL.Safety Instructions 1. When carrying the CD Player, use the originalshipping carton and packing materials. It's the best way to protect the play with the factorypackage. 2.Don't place the CD Player nearby volatileliquid, and don't let the rubber or plastics productto connect with the player for a long time, whichwill leave traces on the machine cover. 3. After working for a long time, the upper covereor rear panel will give out heat, which belongs tonormal phenomenon not malfunction. 4. While not using the CD Player, please takedisc out and close the disc chamber, then turn offthe power. 5. While not using the CD Player for a long time, some functional button may not work. In order toavoid appearing that phenomenon, advise to useit for a while or pay attention to moistureproof.LOCATION PRECAUTIONSWhile placing the CD Player at the side of TV, Radio or Video Recorder, it may appear phenomenon like the picture showed not clear orthe sound loses true. Therefore, keep the CD Player away from that kind of equipment.CLEANING PRECAUTIONS1. Cleaning by a soft cloth2. Using a cloth with a little bit diluted detergent to wash the stain. Please remind that don't use any dissolvent such as thinner,gasoline solventsand volatile liquid, for which will damage the player cover.3. Using chemical soaked cloth to clean the CD Player, Please wash the player according to the usage instruction.NOTE: Cleaning and adjusting interior parts haveto be operated by qualified maintanence worker,otherwise damage the player or shorten usage life.DISC USAGE PRECAUTIONS1. How to get a disc: don't touch the side of playing 2. Cleaning Disc: clean the disc from the centerto outside by a soft cloth. If the picture and soundquality was influenced because of fingerprints ordust on the disc, wiping the disc by a wet cloth and then wiping by a dry cloth. Don't use Dissolvedin toluene, detergent or Anti static spray to washthe disc, or damage it. 3. Storing the disc: placing the disc to the disc box instead of humid or dusty place and directsunshine place. BATTERY PRECAUTIONS If using batteries incorrectly, the battery fluid would leak or the baterry will becorroded.Therefore,please operate correctly as thefollowing instruction. 1.While putting batteries into remote control, don't take anti to the positive and negative polarityof the battery. 2.Don't charge the battery (not rechargeable batteries), disassemble and decompose the battery or put it into fire. 3.Don't use different models batteries togetheror new batteries with old ones. 4.Don't leave damaged or dead battery into the remote control. 5.If not using the remote control for a long time,put batteries out to proctect it from being damagedfor battery fluid leaking. 6.If the remote control work abnormally or effective picture narrows, replace new batteries. 7.If battery fluid leaks, clean the battery casefirst and then replace new battery.Precautions12
CD DoorRepeatPress to repeat thecurrent track. Presstwice to repeat theentire album.Skip/Search Press to skip between tracks on a loaded CD. Press and hold to search through the current track.Stop Press to stop a CD during playPlay/PausePress to play or pause a loaded CD.ProgramPress to program the loaded CD to play tracks in a specified order.LCD DisplayCD/Line In, Off, FM, AM Adjust to switch between CD/Line In, Off, FM or AM modes.Tuning In radio mode, turn to adjust the AM or FM radio station.AC Power InputVolume Turn to adjust thevolume.3.5mm Audio To power the unit, plug the power cord (included) into the AC Power Input on the back of the unit and a standard AC power outlet. For battery power, this unit requires 6 C-size, batteries (not included).CDLoading and Playing a CD Note: This unit is not compatible with MP3 CDs. 1. Open the CD door and place a CD in the boombox, label side facing up. 2. Close the CD door. 3. Adjust the Source Switch to CD mode. 4. Press the Play/Pause button to begin playing the loaded disc. Programming a CD 1. Press the Stop button to stop a loaded CD. 2. Press the Program button. “01” will blink on the display. 3. Press the Skip/Search buttons to select a track. 4. Press the Program button to add the selected track to the program. 5. Repeat steps 3 and 4 to program up to 20 tracks to play in a specified order. 6. Press the Stop button to cancel a program.RADIORadio Reception An AM and FM antenna is built into the radio. To improve radio reception, adjust the position of the boombox.Playing the Radio1. Slide the Source Switch switch to AM or FM radio mode. 2. Adjust the Tuning dial to tune the radio.3.5 MM AUDIO INPUTUsing the Line In 3.5 mm audio input cable not included. 1. Plug one end of a 3.5 mm audio input cable into the Line In input on the back of the unit, and plug the other end of the cable into the audio output on an MP3 Player or other audio source. 2. Press the Power button to power the unit on. 3. Slide the Source Switch on the front of the unit to Line In. 4. Audio played through the connected device will now be heard through the speakers.34
56WARRANTYPhenomenon Cause MeasurementNo powerConnect the power plug rightDisconnect the power plugDon't work afterbeing energized Put Disc into the CD player No DiscNo sound Not connecting to the right jack Disconnect the Audio Input lines Equipment connected doesn't work or Volume is 0 connect the Audio Input lines connecting to the right jack MakeEquipment connected work or turn the volume upTROUBLE SHOOTINGConsumed Power: 12WDisc Support: CD/CD-R/CD-RWFM: 87.5-108.0MHzAM: 520-1710KHzPower Supply: AC~230-240V, 50Hz or DC 9V (UM-2)X6Batteries (Excluding Battery)Temperature: -10°C ~+45°CHumidity: 15-75%(without the water drop)THE MAIN TECHNICAL PARAMETER
