
XP-20/HD
ANTIGRAVITY BATTERIES // 310 527 2330 // INFO@ANTIGRAVITYBATTERIES.COM Page 2 of 11
USER MANUAL
SAFETY PRECAUTIONS
READ AND UNDERSTAND ALL SAFETY INFORMATION BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE
SAFETY INSTRUCTIONS MAY RESULT IN ELECTRICAL SHOCK, EXPLOSION, FIRE, WHICH MAY RESULT IN SERIOUS
INJURY, DEATH OR PROPERTY DAMAGE.
1. Do not leave the product in, or expose product to extremely high temperatures such as on dashboards or other
extremely hot areas above 110°F (43°C).
2. Do not use product for any use other than intended.
3. Do not use Jump-Start Port to power devices, it is ONLY for Jump-Starting.
4. Do not Jump-Start with less than 40% on Capacity Indicator. It may not start the vehicle.
5. Do not Jump-Start more than 5 seconds per attempt (overheating may occur).
6. Do not Jump-Start more than 3 attempts in a row without allowing to cool.
7. Do not start the vehicle continuously for more than 4 times within 10 minutes. If the engine fails to start successfully
within 3s after the rst start, stop cranking and wait at least 1 minute to start the vehicle again.
8. Do not leave the product connected to vehicle. Remove within 30 seconds of starting vehicle.
9. Do not clamp the Red and Black Clamps together.
10. Do not connect the Clamps to the battery reversely after pressing the ‘’BYPASS’’ button.
11. Do not use the product to start a vehicle while charging the XP-20 itself.
12. Do not recharge this product immediately after starting the vehicle. Let it cool for 15 minutes rst.
13. Only use the provided jumper clamps to start vehicle.
14. Do not charge frozen batteries. Only charge between ambient temperatures of 33~113°F (0~45°C).
15. Do not leave battery products unattended while charging.
16. Do not allow Children to play with this product. Not recommended for use by inrm persons.
17. Don’t over-discharge the unit (don’t let battery run out). Charge it regularly, preferably every 3 months if not in use.
18. Do not store in locations where the temperature may exceed 113°F (45°C).
19. Do not use as a replacement battery for vehicles, or as a battery charger for your vehicle’s battery.
20. Do not allow the product to be immersed in water.
21. Do not expose the product to extreme heat or re. Do not operate it in explosive atmospheres, such as in the
presence of ammable liquids, gases or dust.
22. Discontinue use of product if it swells or expands, or if any cable, clamp, or cord is damaged.
23. Under extreme conditions, the battery may leak. In this case do not handle product with bare hands. If there is skin
contact, wash immediately with soap and water. If the liquid accidentally touches eyes, immediately rinse the eyes
with water for at least 10 minutes and seek medical help.
24. The device contains a lithium battery. At the end of the product’s service life, or if the device leaks liquid, dispose of
the device according to local regulations. Do not modify or disassemble.
OPERATING PRECAUTIONS
1. Make sure the PLUG for the CLAMPS is plugged and seated fully into the XP-20. This connection must be good or
it could overheat the unit.
2. Make sure to check that all the battery connections are clean. Remove corrosion or dirt that prevents a solid
connection of clamps to vehicle battery terminals.
3. Make sure clamps have a good “bite” on Battery Terminals for best transmission of power to vehicle.
4. Make sure the XP-20 has a minimum of 40% on the Capacity Indicator lit before Jump-Starting.
5. Make sure to remove the product from the vehicle battery within 30 seconds of Jump-Starting.
6. Remove Clamps from the XP-20 when not in use.
Safety Precautions