Anuraco BLE-485 User manual

BLE-485 Bluetooth Adaptor
Getting Started Guide
User Requirements (PC version)
AA 3.6v lithium battery
Windows PC 7, 10 64bit
Internet connection
Smart sensor software (like Aqua4Plus)
RS485 M12 connector
RS485 MODBUS
SENSOR
+ Stored data logs
+ Real-time data output
BLUETOOTH ADAPTOR
+ Talks to sensor and sends
data to bluetooth enabled
device
+ Can be used to network
locally or remotely with
bluetooth gateways
Bluetooth to RS485 Basics
Support [email protected] +1 425.820.8221
RS485 WIRED M12 CONNECTION
+ Sensor wired to BLE-485 via
RS485 M12 connector
BLUETOOTH DEVICE
+ Receives info from Bluetooth
beacon
+ Creates COM port connected
to apps, or data analytics
programs to translate sensor
data.

NOTE: BLUETOOTH DONGLE DEFAULT NAME IS CSR8510 A10
YOU WILL NEED TO KNOW THIS FOR THE PC APP INSTALL!
Ignore any dongle self-install messages.
Install AA 3.6v lithium battery
by unscrewing bottom connector.
Turn Adaptor on
Screw cap clockwise for on.
Counter-clockwise for off.
LED will signal BLUE (for first minute only) when ON.
Put Bluetooth 4.0+ dongle in USB port
Download and install Anuracom app software
Go to anuraco.com/registration to download for PC
IMPORTANT !!!! YOU MUST CHOOSE THE BLUETOOTH DONGLE DEFAULT FROM
THE DROPDOWN (NAME: CSR8510 A10) DURING PC APP INSTALL !!!!
Wire BLE-485 Adaptor to Sensor with RS485 M12
connector
Open Anuracom app
Click the adaptor name to connect to it and to access settings + sensor data.
To view and download data, open Aqua4Plus or
sensor software and manage sensor data live
through COM port connection (see manual for full
instructions)
1
2
3
ON OFF
4
5
6
7
NOTE:
LED will signal GREEN when Adaptor is communicating.
LED will signal RED if low on battery.
Support [email protected] +1 425.820.8221
Please read all instructions before starting.
Installation for PC Windows 7,10 app version only
+-
M12
Connector Top cap
Circuitboard
3.6V Li
BOTTOM TOP
Insert lithium battery