Apollo Ezivac User manual
EziVac Risk Minimisation
The EziVac is a drum mounted vacuum pump
used for removal of fluid from sumps, tanks and
clean-up of spills. It is capable of vacuuming
semi-solid liquids as well as transferral of said
liquids from drum to an alternate storage tank.
Warning - The assembly and
operating instructions must be read
and understood before using EziVac
products.
The EziVac is designed to be used in the
following manor;
Not to be used with flammable liquids.
Do not exceed 100psi air supply - this may
collapse a drum under vacuum.
Only use drums that are in good condition,
with no dents. Compromised drums may
collapse under vacuum.
Only vacuum liquids from 0 to 60°C.
Use hearing protection at all times.
Warranty Summary - Refer to
www.apolloengineering.com.au\express
warranty policy for Terms and Conditions
Assembly
and operating
instructions
Manufacturing simple solutions
for complex problems
A
B
C
D
E
F
G
H
I
J
K
L
M
1.
Fit the nitto fitting to the slide valve on the
Ezivac.
2.
Install the Ezivac into the ¾” drum port.
3.
Screw the control knob on the Ezivac all
the way out to ensure the Ezivac is set to
vacuum.
4.
Connect Tube 1 to Tube 2 using the
stainless socket.
5.
Screw the Tube 1 into the bottom of the
bush.
6.
Screw the elbow into the top of the bush.
7.
Screw the camlock adapter into the elbow.
8.
Cut the end o tube 2 so that it sits o
the bottom of the drum by approximately
20mm.
9.
Screw the assembly into the 2” drum
opening.
10.
Connect the hose to the camlock coupling.
11.
Insert the adapter into the opposite end of
the hose to the camlock coupling.
12.
Insert the wand into the adapter.
13.
Insert the gulper tool or the crevice tool
into the wand.
Assembly and
operating instructions
For more information and videos
apolloengineering.com.au/ezivac
PARTS
A. Drum (not included)
B. EziVac
C. Tube 1 and 2
D. Stainless Socket
E. S/S Bush
F. Elbow
G. Camlock Adapter
H. Camlock Coupler
I. Hose
J. Hose Joiner
K. Wand
L. Crevice Tool
M. Gulper
