APURO GL346-A User manual

Model:
GL346-A/GL347-A/GL348-A/GL349-A
Water Boiler
Instruction manual
GL346-A_GL349-A_A5_v4_170713.indb 1 2017/7/13 16:16

2
AU Telephone Helpline: 1300225960
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
• Ensure the location for the appliance can support its weight
when full.
• DO NOT immerse the appliance in water.
• DO NOT leave the machine unattended during operation.
• DO NOT operate this appliance when less than one third full.
• DO NOT touch the outer surfaces of the appliance. They
become hot during use.
• Suitable for indoor use only.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an
Apuro agent or a recommended qualified technician in order
to avoid a hazard.
• Please ensure that the tap is screwed fully on before use.
• Apuro recommend that this appliance is PAT tested
on an annual basis to ensure the product remains safe.
GL346-A_GL349-A_A5_v4_170713.indb 2 2017/7/13 16:16

3
AU
Telephone Helpline: 1300225960
Product Description
GL346-A - 10.5 litre Stainless Steel Water Boiler
GL347-A - 20 litre Stainless Steel Water Boiler
GL348-A - 30 litre Stainless Steel Water Boiler
GL349-A - 40 litre Stainless Steel Water Boiler
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Apuro product.
Pack Contents
The following is included:
• Apuro Water Boiler • Instruction manual
Apuro prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Apuro dealer immediately.
Operation
1. Remove the appliance from the packaging. Make
sure that all protective plastic film and plastic
coatings are thoroughly removed from all surfaces.
Note: Before using for the first time,
clean the interior of the appliance
and all parts in warm soapy water,
then rinse thoroughly.
2. Ensure the Temperature Control knob is set to ‘OFF’.
3. Remove the lid and fill the appliance to at least half
of its capacity.
4. Replace the lid.
5. Connect to the mains power supply.
6. Set the Temperature Control knob to the required
temperature setting. The ‘BOIL’ indicator light
illuminates and the appliance begins to heat water.
Tap
KEEP WARM
indicator light
Temperature Control knob
Handle
Lid
BOIL indicator
light
WARNING: Reduce the set temperature if the water begins to boil. DO NOT
allow the water to boil constantly.
7. When the water has reached the set temperature the ‘BOIL’ Indicator light turns off and
the ‘KEEP WARM’ indicator light illuminates.
GL346-A_GL349-A_A5_v4_170713.indb 3 2017/7/13 16:16

4
AU Telephone Helpline: 1300225960
Note: Once the water temperature drops 5-10ºC then the appliance will reheat
the water.
WARNING: If the Temperature Control Knob is set to or close to ‘HIGH’ then
the appliance will constantly heat the water until knob is turned to ‘OFF” or the
temperature is reduced.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels
the appliance will automatically cut power.
The Safety Cut-out switch is located on the underside of the appliance. To reset the appliance:
1. Empty the appliance and allow to cool.
2. Press the reset button until it clicks.
WARNING: Ensure the appliance has cooled down and is empty before resetting
the switch, as it may need to be tipped slightly to gain access to the switch.
3. The appliance is now reset and can be used as normal.
Serving
1. Place a suitable vessel beneath the tap.
2. Pull the tap towards you or push tap away from you to begin pouring.
3. Raise the tap handle to close the tap.
Emptying the Appliance
Drain the appliance by using the tap to empty.
GL346-A_GL349-A_A5_v4_170713.indb 4 2017/7/13 16:16

5
AU
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
De-scaling
In hard water areas lime scale can build up within the appliance after prolonged use. To de-scale the
appliance:
1. Pour a solution of de-scaler and water into the appliance.
2. Brush the interior gently with a soft bristled brush.
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back On to flush out the system. Flush out the system
thoroughly to remove any de-scaler residue.
5. The appliance is now ready for use.
Note: Use a suitable de-scaler and always follow the instructions on the
container.
Apuro recommend that this appliance is de-scaled every 3 months or more
frequently in hard water areas.
Troubleshooting
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call Apuro agent or qualified Technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call Apuro agent or qualified technician
Thermal fuse has activated Reset Thermal fuse (see page 4)
Power light comes
on but water
does not reach
temperature
Thermostat fault Call Apuro agent or qualified technician
The tap is leaking The tap has become loose Tighten the tap handle
GL346-A_GL349-A_A5_v4_170713.indb 5 2017/7/13 16:16

6
AU Telephone Helpline: 1300225960
Technical Specifications
Model Voltage Power Current Capacity
(litres)
Weight
(full)
(kg)
Approx. Heating
Time (Max.
Temp. when full)
Dimensions
h x w x d mm
GL346-A 230V 50Hz 2200W 9.6A 10.5 16.8 25 minutes 470 x 313 x 326
GL347-A 230V 50Hz 2200W 9.6A 20 29.2 50 minutes 535 x 369 x 380
GL348-A 230V 50Hz 2200W 9.6A 30 40.4 70 minutes 519 x 433 x 440
GL349-A 230V 50Hz 2200W 9.6A 40 48.2 100 minutes 630 x 433 x 440
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
APURO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
APURO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of APURO.
Every effort is made to ensure all details are correct at the time of going to press, however, APURO reserve the right to
change specifications without notice.
GL346-A_GL349-A_A5_v4_170713.indb 6 2017/7/13 16:16

DECLARATION OF CONFORMITY
Equipment Type
Water Boiler
Model GL346-A/GL347-A/GL348-A/GL349-A
Serial Number
Year of Manufacture
Application of Council Directives(s) C-TICK
AS/NZ 3820 Essential Safety Requirements for Low
Voltage Electrical Equipment
Standards
Producers Name Apuro
Producers Address
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Date 20/01/2015
Signature
Full Name
Richard Cromwell
Position Commercial Director
Nisbets Australia PTY Ltd
15 Badgally Road
Campbelltown
NSW 2567
Australia
AS/NZS CISPR14.1:2013
IEC60335.2:75-2012
IEC60335-1:2010
GL346-A_GL349-A_A5_v4_170713.indb 7 2017/7/13 16:16

GL346-A_GL349-A_A5_v_170713
GL346-A_GL349-A_A5_v4_170713.indb 8 2017/7/13 16:16