Aqua Lung Outlaw User manual

© 2017 Aqua Lung International
TABLE OF CONTENTS
Outlaw / Rogue
General Information
Outlaw / Rogue Components
ModLock™ Connectors
Waistband / Shoulder Strap Assembly
Aircell Assembly
Weight Pocket Assembly
ModLock™ Connector Disassembly
Waistband Extender
Double Cylinder Setup
Anchorline Retainer
BC Specications

© 2017 Aqua Lung International
Table of Contents
COPYRIGHT NOTICE
This manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-readable form without prior
consent in writing from Aqua Lung®. It may not be distributed through the internet or computer bulletin
board systems without prior consent in writing from Aqua Lung®.
© 2017 Aqua Lung®International BC Owner’s Manual
Aqua Lung®is a registered trademark of Aqua Lung International
WARNINGS, CAUTIONS AND NOTES
Pay special attention to information provided in warnings, cautions and notes that are accompanied by
one of these symbols:
WARNINGS: Indicate a procedure or situation that may result in serious injury or death if
instructions are not followed correctly.
CAUTIONS: Indicate any situation or technique that will result in potential damage to the
product, or render the product unsafe if instructions are not followed correctly.
NOTES: Are used to emphasize important points, tips and reminders.
GENERAL INFORMATION
General information can be found in the Buoyancy Compensator User’s Guide that has been provided
with this product. The Buoyancy Compensator User’s Guide is also available on the Aqua Lung®website
at www.aqualung.com

© 2017 Aqua Lung International
Table of Contents
OUTLAW / ROGUE COMPONENTS
Aircell
Shoulder Straps
Waistband
SureLock™
Weight Pocket
Trim Weight
Pocket
Waistband
Extender
Anchorline
Retainer
Harness
GripLock
™
Tank Band
Waistband
Dump Valve
(Rogue Only)

© 2017 Aqua Lung International
Table of Contents
MODLOCK™CONNECTORS
Shoulder Connector
(Male)
Shoulder Connector
(Female)
Shoulder Connector
(Female)
Waistband Connector
(Female)
Waistband Connector
(Female)
SureLock or Trim Weight
Pocket Connector
(Dual Female)
Waistband Connector
(Male)
Waistband Connector
(Male)
SureLock™Weight
Pocket Connector
(Dual Male)
Trim Weight
Pocket Connector
(Dual Male)
Trim Weight
Pocket Connector
(Rogue Only)

© 2017 Aqua Lung International
Table of Contents
WAISTBAND AND SHOULDER STRAP ASSEMBLY
1. Place the harness on a at surface with the ModLock™connectors face up. Position the waistband
and shoulder straps next to the harness where they are to be attached with the ModLock™connectors
face down.
2. The female buckle will be on the right side and male buckle on the left side when the waistband
is attached properly to the harness. Place the male connector on the waistband over the female
connector on the harness and slide it into place. An audible “click” will conrm the connectors are
locked, securing the waistband in place.

© 2017 Aqua Lung International
Table of Contents
AIRCELL ASSEMBLY
1. Unclip the upper tank strap and separate the hook and loop tabs on the retainer. Unbuckle the tank
band and lay it out across the harness.
3. Make sure the chest strap is facing inward when attaching the shoulder straps to the harness. Place
the male connector on the shoulder strap over the female connector on the harness and slide it into
place. An audible “click” will conrm the connectors are locked, securing the shoulder strap in place.

© 2017 Aqua Lung International
Table of Contents
3. Insert each side of the tank band through the lower slots in the aircell. Attach the lever to the bail
securing it in place.
2. Place the aircell onto the harness with the hook and loop retainer face down, directly over the tank
band. Fold the bottom of the aircell upward to access the retainer and separate the hook and loop tabs.
Slide the loop tab under, then back over the tank band and attach it to the small hook tab. Fold the large
hook tab over the loop tab to nish securing the bottom of the aircell in place.

© 2017 Aqua Lung International
Table of Contents
5. Insert T-shaped web lock at the top of the aircell through the plastic loop on the shoulder strap.
Check to ensure the T-shaped web lock is secured in place. Repeat process for other side.
4. Bring the upper tank strap along with the hook and loop tabs through the upper slots in the aircell.
Secure hook and loop tabs along with the upper tank strap to hold the top of the aircell in place.
NOTE: The 35 lb aircell for the Rogue BC is equipped with a right shoulder dump valve and cord assembly.
To attach the pull dump cord, insert the male end into the female end of the T-Lock connector and twist to
secure the cord in place. To test the connection, pull down on the knob to make sure the dump valve activates.

© 2017 Aqua Lung International
Table of Contents
WEIGHT POCKET ASSEMBLY
1. Optional SureLock™or trim weight pockets can be attached to the dual connectors on the harness.
When attaching the SureLock™weight pockets ensure the release handle is pointed downward. Trim
weight pockets can face either direction.
SureLock™Weight Pocket Trim Weight Pocket
6. Connect both shoulder straps to the adjustment
straps.

© 2017 Aqua Lung International
Table of Contents
2. Align the dual male connectors on the weight pocket with the female connectors on the harness and slide
into place. An audible “click” will conrm the connectors are locked, securing the weight pocket in place.
3. To release the SureLock™weight pouches
simply pull on the handle. Trim weight pockets
are non-releasable.
WARNING: The SureLock™weight pocket must be attached with the handle facing downward in
order to release properly.