Aqua-Marina EP-T16 User manual

Operation Instructions
AQUA MARINA
ELECTRIC PUMP
Please read the operation instructions carefully
before using this product.
(Max. Air Pressure 16PSI)
EP-T16

Index
2
I. Content List..................................................
II. Overview ...................................................
III. Safety Instructions.......................................
IV. Inflation Operation........................................
V. Precautions..................................................
3
3
4
5
6
7
7
8
VI. Trouble Shooting.........................................
VII. Maintenance and Storage..........................
VIII.Warranty.....................................................
EP-T16

I. Content List
Please check if all the following parts are in the box before use.
If any part is missing, please contact the local dealer for help.
Air PumpHose Battery Clamp
User Manual
Inflation inlet
LCD screen
PSI/BAR toggle button
Up button
Down button
On/Off button
DC plug
Air nozzle
Hose
Flexible conduit adaptor
Air inlet
Battery clamp
II. Overview
3
1
2
3
4
5
6
7
8
9
10
11
12
12
EP-T16
2
3
4
5
6
1
10 11
7
8
9
16.00

4
III. Safety Instructions
*
Warning: To reduce the risk of injury, do not let children use it. Always
supervise children and those who are incapacitated.
*
Warning: This product is not suitable for people with reduced physical
strength, sensory ability or mental faculty, people who lack skills and people with
intellectual disabilities, unless they are under the protection of a guardian and are
supervised and guided.
*
Warning: Unplug the DC power before moving, maintaining, repairing or
adjusting this product
*
Warning: Do not bury the wire in soil. It shall be placed in the safe zone where
it won't be damaged by mower or other equipment.
*
Warning: If the power cord is damaged, it must be replaced by the
manufacturer or its service agent or similar authorized personnel to avoid
danger.
*
Warning: If you are standing in a place with water or your hands are wet,
please don't operate the power plug.
*
Warning: Check the maximum air pressure of the inflatable product before
inflating. The air bag can be damaged by exceeding the Max. air pressure.
*
Warning: Check the cigarette lighter socket before use to ensure that there is
no rust or residue inside. The poorly conductive cigarette lighter socket may
cause overheating of the product or power supply, which may damage the
product.
*
Warning: The purpose of using this product is limited to the description
described in the manual.
*
Warning: Do not use this device in an ambient temperature above 40℃.
*
Warning: The air pipework for this product is only applicable to the original
hoses.
*
Warning: Before use, check whether the air pipe is broken, whether the switch
is normal, and whether the cigarette lighter can be energized normally.
*
Warning: Avoid high temperatures, humidity, dust and direct exposure to
sunlight.
EP-T16

* Connect the end with flexible conduit adaptor ⑩ of the hose to the air pump
inflation inlet ①, and twist clockwise to tighten it as Figure 1.
* Install the other end of the hose into the supporting air tap of the air
bag (step 1 in Figure 2).
* Plug the DC plug into the 12V DC socket.
* Press the toggle button to switch the unit of air pressure.
* Press the UP button or DOWN button to set the pressure value
you need, with the range of the pressure value from 0 to 16PSI,
(1PSI=0.0689BAR)
* After finishing the above steps, press the On/Off button to start
inflation.
* During the inflation process, you can press the UP button or DOWN
button to increase or decrease the targeted air pressure, press the
toggle button to switch the unit of air pressure, and press the On/Off
button to stop.
* When the air pressure reaches the set value, the air pump will stop
automatically.
* When the inflation is completed, unplug the power cord.
* When not in use, remove the inflation hose from the air pump and store it
properly.
5
IV. Inflation Operation
EP-T16
（Figure 1）（Figure 2）

*
The applied power source must be the 12V DC power source (as Figure 3).
*
Do not block the inflation inlet ①, and ensure that the inflation inlet ①shall
remain smooth at all times.
*
Observe the local waste treatment provisions, and it is not allowed to throw
the air pump away randomly.
*
Don't use this product when the hose is damaged.
*
Don't pull out the hose when inflating, because
the high pressure may hurt you.
*
Don't keep the air pump working for more than 15
minutes, because motor overheating may
cause internal damage. The air pump shall
be fully cooled for 30 minutes after continuously
working up to 15 minutes.
* Notice: The factory default setting air pressure is 10PSI (10PSI=0.689BAR).
From the second-time use, the default air pressure will be the value you set
in last time.
* Notice: When the air pump is powered on and without any operation over 2
minutes, it will enter standby mode. You can press the On/Off button
to re-activate the pump.
* Don't use this air pump if any part is damaged. Please contact local dealer
for after-sales service.
* This product shall not be exposed to the rain or immersed in water.
* The inflation inlet should not point to the face or body while working.
* Do not leave the air pump unattended while inflating.
* Do not turn off the car engine when the product is in use to avoid
unnecessary damage.
6
V. Precautions
EP-T16
（Figure 3）

* After use, you may want to move, repair or adjust this product. Unplug the
power plug from the outlet beforehand.
* When it is not in use, it shall be properly stored after being fully cooled.
* It shall not be exposed to direct sunlight or immersed in the water.
* Please store it in dry and ventilated place.
* Do not drop or violently shake the pump.
7
VI. Trouble Shooting
VII. Maintenance and Storage
Fault Inspection Solution
The air
pump
cannot be
started
normally
1. The power source is
not plugged properly.
2. The fuse in DC plug
⑦ is burnt out.
3. Overheating or
overload causes motor
stop.
1. Make sure that the power wire is
plugged in the 12VDC socket.
2. Change the fuse.
3. Cool the motor and restart it.
4. If the problem cannot be solved,
please contact local dealer for
after-sales service.
1. Change the hose or make sure it
is unblocked. If the hose is cracked,
replace with a new hose.
2. Reinstall the hose.
3. If the problem cannot be solved,
please contact local dealer for
after-sales service.
1. Check whether the
hose ⑨is blocked or
cracked.
2. The joint between
the hose and air pump
or air valve is not
installed properly.
Slow or
abnormal
inflation
EP-T16

• This product has a limited TWELVE (12) months warranty.
1. AM will make the final warranty determination, which may require inspection
and/or photos of the equipment, which clearly show the defect(s). If necessary,
this information must be sent to the AM distributor in your country with prepaid
postage. Product can be returned only if a return authorization number is given
in advance by the AM distributor. The return authorization number must be
clearly labelled on the outside of the package, or it will be refused.
2. If a product is deemed to be defective by AM, the warranty covers the repair or
replacement of the defective product only. AM will not be responsible for any
costs, losses, or damages incurred as a result of loss or misuse of this product.
3. This warranty does not cover damage caused by misuse, abuse, neglect, normal
wear and tear including, but not limited to, punctures, damage due to excessive
heat exposure, damage caused by improper handling and storage, or damage
caused by anything other than defects in material and workmanship.
4. This warranty is void if any unauthorized repair, change or modification has been
made to any part of the equipment.
5. The warranty for any repaired or replacement equipment is good from the date
of the original purchase only.
6. The original purchase receipt must accompany all warranty claims. The name of
the retailer and date of purchase must be clear and legible.
7. There are no warranties that extend beyond the warranty specified here in.
This product is designed in accordance with standards for
a specific use. Any modifications or transformations higher
than that indicated by the manufacturer could result in
serious risks for the user and will void the warranty.
WARNING
WARRANTY
AM warrants this product to be free from major defects in material or
workmanship to the original purchaser for below specified period from
the date of purchase. This warranty is subject to the following limitations:
© Oriental Recreational Products (Shanghai) Co., Ltd
®™Trademarks used in some countries of the world under license to / ®™marques
utilisées sous licence de / Marcas registradas utilizadas en algunos paises del mundo bajo
licencia de / Das®™ Warenzeichen wird in einigen Ländern der Welt unter der Lizenz
davon benützt / Oriental Recreational Products (Shanghai) Co., Ltd., No.1699, Daye Road,
Shanghai, China 201402 • Represented in the European Union by / Représenté dans
l'Union européenne par / Innerhalb der Europäischen Union vertreten durch /
Representado en la Unión Europea por / ORPC S.A.S. 17 avenue George V 75008 Paris -
France • Represented in the UK by / Représenté au Royaume-Uni par / Innerhalb des
Vereinigten Königreichs vertreten durch / Representado en Reino Unido por / Marine &
Outdoor Ltd. Birch Farm, Brooks Road, Raunds, Wellingborough NN9 6NT, UK