ARB BASE RACK 1780220 User manual
Last Rev Date: 06/11/2020
Page 1 of 2
Fitting instructions# 3789983
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
Part Number:
1780220 & 1780230
Product Description:
BASE RACK T-Slot adapter (Single & Pair)
WARNING
The ARB BASE RACK system has a maximum capacity of 25kg per cross slat. Exceeding this limit
may result in damage or failure
This product must be installed exactly as per these instructions using only the hardware supplied
Do not use this product for any product, other than those specified by ARB
This product or its fixing must not be modified in any way
These instructions are correct as at the publication date
During installation, it is the duty of the installer to check correct operation/clearances of all
components
Work safely at all times
Unless otherwise instructed, tighten fasteners to specified torque
Fastener torques are to be checked at regular intervals
ARB 4x4 ACCESSORIES
Corporate Head Office
www.arb.com.au
42-44 Garden St Tel: +61 (3) 9761 6622
Kilsyth, Victoria Fax: +61 (3) 9761 6807
AUSTRALIA 3137
PARTS LISTING
KIT NUMBER
APPLICATION.
PART NO.
QTY
DESCRIPTION
1780220
6191060
1
EXTRUSION T-SLOT ADAPTER 100MM
6191075
1
EXTRUSION BASE ADAPTER M6
6151256
2
SCREW BHD M6x16 SS
1780230
6191060
2
EXTRUSION T-SLOT ADAPTER 100MM
6191075
2
EXTRUSION BASE ADAPTER M6
6151256
4
SCREW BHD M6x16 SS
Last Rev Date: 06/11/2020
Page 2 of 2
Fitting instructions# 3789983
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1. Assemble as shown
2. Loosen the M6 screws and slide over the
BASE RACK dovetail
3. Slide to desired location
4. Tighten screws to specified torque
5. Install accessory as per manufacture’s
instruction
Note: T-bolt shown for illustration purpose only
This manual suits for next models
1
Table of contents
