15
V 10/16
HOW TO USE THE APPLIANCE
Position the appliance on a flat, stable surface.
Take the top part of the appliance by the sides with both hands and turn upside-down.
Open the tank cap by turning it anti-clockwise; fill the tank with water and then close it again.
Turn the tank and place it on the base.
After properly filling the water tank and repositioning the tank on the unit, connect the plug with the electrical socket,
checking that the mains voltage meets the product requirements (220-240V~50-60Hz).
The decorative LED around the button will light up red and the appliance will be on standby.
Hold down the button to activate the appliance.
You can adjust the amount of steam released by turning the button clockwise (to increase it) or anti-clockwise (to
decrease it).
Below are some instructions on how to use the middle button correctly.
Operation Status N.B.:
Press and hold the button Turn the appliance on/off Press the button for 0.5 – 1 second
Short press the button Enable/disable the LED light ring Press the button
Turn the middle button clockwise Increase the amount of steam The default setting is for average
volume (if you increase the volume,
the last setting will be stored)
Turn the middle button anti-clockwise Decrease the amount of mist The default setting is for average
volume (if you increase the volume,
the last setting will be stored)
Red light on Standby The red light will disappear after 5
seconds if the appliance is not
running
White light on Standby The white light will disappear after 5
seconds if the appliance is not
running
Red light flashing, then turned on There is a water shortage in the tank
or the tank has been removed
The red light stays on after flashing
for 30 seconds
The appliance will continue to humidify at the intensity level selected until all water has been used up from the tank.
When there is no more water in the tank, the red LED will flash for 30 seconds and then stay on, to indicate the need to
fill the tank in order to continue operation.
Unplug the mains, lift the tank with both hands, turn it and fill it with clean water. Then reposition it, reconnect the mains
and hold down the middle button.
Use clean water every time the appliance is used in order to guarantee a longer life-span and increased effectiveness of
the humidifier.
The appliance will switch off automatically when the tank is removed or if there is a shortage of water.
If you wish to add fragrances to perfume the room, remove the lid of the fragrance compartment, pour in a few drops of
essential oil and close the compartment: do not add any fragrances directly to the water in the tank.
To avoid any interruption of operation due to a lack of water during night-time use, it is recommended to fill the tank at
least ¾.
WARNING!!
It is normal for water to collect on the bottom of the appliance: the water passes from the tank into the base of
the unit to trigger the ultrasonic humidification mechanism.
Be careful when removing the water tank for filling/emptying or cleaning operations, as the water accumulated
on the bottom may drip from the tank.
Dry the tank with a towel to avoid getting the floor or furniture wet.
WARNING!!
Always use the humidifier in a temperature between 5 °C and 40 °C.
The ideal room humidity is between 40 and 60. The respective humidity should be less than 80%.
Fill the water tank with tap water only, without adding any fragrances or essences.
