Argos A700 User’s Manual
When an impact by an accident is occurred while driving, G-Sensor sense an impact
and will be started impact recording
It will be recorded an impact image of before and after 15 seconds by that point
Buzzer sound ring three times (beep,beep,beep) and Rec LED lights up red
Charging battery is built in A700
Re-charging
Although the engine of car turn off, if you turn off the power of A700, recording will be
processed more than 2 hours continuously
When you disconnect vehicle power from the unit, buzzer sound ring two times (beep,
beep) and charing LED will be turned off
When you connect vehicle power into the unit again, buzzer sound ring two times(beep,
beep) and battery will be recharged automatically
In this case, charging LED lights up red and goes to green when completed
If vehicle power is disconnected or the engine of car is stopped, A700 will process the
Alarm of low voltage
recording by built-in battery continuously
If built-in battery is discharged, A700 sense it and will stop recording automatically
In this case, buzzer sound ring four times (beep,beep,beep,beep) to let you know the
electric discharge of battery and recording LED lights up green
If vehicle power is connected and power of A700 turn on again, A700 will be recharged
and also recording will be started again.
Recording LED will be changed green to orange
A700 have the function of screen reverse regardless of lens orientation
Screen Reverse
Note)
Please turn on the power of A700 again to apply this function normally
8. At this time recording is starting automatically
9. All function of the product is working normally
beep sound (beep)
1. Please check switching off the engine and turning off the power of A700, first
2. Please check inserting SD memory card into A700
3. Please check connecting vehicle power to A700
4. Please switch on the engine of car
5. Please turn on the power of A700
6. Charge LED lights up red
7. Recording LED lights up green during a few seconds and goes to orang with
Operation of the product
10
Recording by G-Sensor