Aria Atelier FM600 Series User manual

Finials - 1 ⅛"
Components included for each Finial:
2. Locate the finial. Check the finial plastic plug to ensure it is
securely attached to finial.
NOTE: If the plastic plug is loose, tighten the plastic plug with a
Phillips screw driver.
3. Finial orientation should be determined before attaching to pole.
4. Align the plastic plug parallel to the pole.
6. To complete installation push the finial until it contacts the pole.
(Hold the finial in the desired orientation during this step).
5. Insert the plastic plug into the pole, while keeping the plastic
plug parallel to the pole, and the finial in the correct orientation.
Finial Installation for Pole Mount:
1. Install all hardware and pole.
Finial Removal Instructions:
1. To remove the finial, pull the finial straight out of the rod
without twisting.
2. Keep the finial parallel to the pole during removal to prevent
damaging the plug. If the plug is damaged, continue to step 3.
• Plastic Plug (comes attached to finial).
AriAMetalHardware.com 1
Thank you for purchasing your new decorative finials. With proper
installation and care, they will provide you with many years of beauty
and trouble-free use. Clean with a soft cloth. Do not use harsh or
abrasive cleaning supplies or polishes which may damage the finish.
Atelier Finials
FM118PL
Components included for each H-Rail Finial:
• Allen Wrench & extra set screw included.
• H-Rail Mount (requires removal of plastic plug to access).
Allen Wrench Extra Set Screw H-Rail Finial Mount
NOTE: The plastic plug is designed to lock in to the pole, ensuring
the finial is secularly attached.
If a finial needs to be removed after it is installed on a pole,
a new plastic plug must be used to insure proper attachment.
It is highly recommended that extra plastic plugs are
purchased in the event a finial needs to be removed.
3. Push finial down until it breaks free of the plastic plug.
© 2019 Rowley®Company, LLC. All rights reserved. AriA®is a registered trademark of Rowley®Company, LLC.
REV April 25, 2019

2
AriAMetalHardware.com
Finial Installation for H-Rail Mount:
1. Install all hardware and H-Rail.
2. Locate the finial.
3. Remove the plastic plug by loosening the set screw.
6. Loosen the H-Rail mounting set screw.
7. Attach plug to the H-Rail mount. Hand tighten the fastener plus ½ turn.
8. The finial is ready to attach to the pole. Follow steps 1 thru 6 below.
A B
7. Place the finial into the H-Rail track by aligning the finial mount
to the H-Rail .
8. Push the finial until it contacts the H-Rail track.
9. To complete your finial installation, tighten the set screw.
5.
6. Rotate the finial mount to the desired location and tighten
the Phillips head screw to hold the finial in place.
If needed, adjust the finial orientation by loosening the Phillips
head screw and rotating the H-Rail finial mount.
© 2019 Rowley®Company, LLC. All rights reserved. AriA®is a registered trademark of Rowley®Company, LLC.
REV April 25, 2019
4. Discard or save the plastic plug.
OR
TOOLS
4. Push the plastic plug into pole.
5. Locate the spare plastic plug and Allen Wrench. It is recommended
to purchase spare plastic plugs (FM118PL) with the finials.
FM118PL Allen Wrench