Ariel UNDERMOUNT SINK User manual

P 1
WWW.ARIELBATH.COM
Need Further Assistance?
For more help, please contact us and one of our trusted
experts will be more than happy to provide guidance.
800-509-5070
Monday - Friday
9:00am - 5:00pm (PST)
UNDERMOUNT SINK INSTALLATION GUIDE
D
C
B
A
Base cabinet
Countertop
Sink basin
Backsplash
INCLUDED
Hardware
Permanent marker
Silicone - (Recommend Liquid
Nails #LN-933 OR Loctite
#PL530 OR GE Silicone II #M90010)
Epoxy - (Recommend Loctite
#1365868 OR Gorilla Glue #4200101)
Caulking gun
NEEDED HARDWARE
STEP 1 - PLACE & TRACE
Place the sink basin on the bottom of the countertop, making
sure to center over the opening. Draw guide lines on the
countertop and the basin in two locations.
MARKER
STEP 2 - PREPARE SINK BASIN
Using a caulking gun, apply a heavy amount of silicone of your
choice on the top side of the sink basin edge.
SILICONE
STEP 3 - FLIP & SET IN PLACE
Carefully flip the sink basin over and place it so the guide lines
match up in both locations.
STEP 4 - DRY & SET
Press down on the sink basin to seal the silicone. Remove any
excess. Follow dry time recommendations found on your
product, typically 12 to 24 hours.
Bolts (4) Undermount clips (4)
Washers (4) Wing nuts (4)

WWW.ARIELBATH.COM
Need Further Assistance?
For more help, please contact us and one of our trusted
experts will be more than happy to provide guidance.
800-509-5070
Monday - Friday
9:00am - 5:00pm (PST) P 2
UNDERMOUNT SINK INSTALLATION GUIDE
STEP 5 - PREPARE & SET BOLTS
Fill in the small holes surrounding the sink basin with epoxy.
Immediately place the top of the bolt (PART A) in the hole
with the epoxy. Allow sucient dry time & follow the package
directions on the epoxy before moving to the next steps,
typically 12 to 24 hours.
EPOXY
STEP 6 - ATTACH UNDERMOUNT CLIPS
After following recommended drying time,
attach the undermount clips (PART B) facing down, place the
washer (PART C) on the clips & use
the wing nuts (PART D) to secure in place. Apply silicone to
the wing nut for added stability.
STEP 7 - PREPARE BASE CABINET
Using a caulking gun, apply silicone around the top of the base
cabinet.
SILICONE
STEP 8 - SET COUNTERTOP IN PLACE
Carefully place the countertop, with the sink attached, onto
the cabinet making sure to line up and center over the cabinet.
There should be ½” overhang on each side of the cabinet and
the front. The countertop edge does not wrap around the base
cabinet, it sits on top. Press firmly down and wipe away any
excess silicone immediately.
STEP 9 - VERIFY COUNTERTOP PLACEMENT
If installed correctly, the countertop should look like the image
above.
STEP 10 - SET BACKSPLASH
After the vanity is in place, use a caulking gun to apply silicone
to the back and bottom unfinished sides of the backsplash.
Press firmly down and back to set in place. Remove any excess
silicone.
D
C
B
A
A