Connect Additional Devices to the Router
Wired:
Connect one end of an Ethernet cable to any YELLOW Ethernet port on the Router and then
connect the other end to the Ethernet port on your device.
Wireless:
You will find the wireless network names and password details on the sticker on the BOTTOM of
your router. Go to your device’s Wi-Fi settings and select a Wi-Fi network name that matches
your router from the list of available wireless networks. Enter the Wi-Fi password to securely
connect your device to your Router.
Personalize Your Router
Open a web browser and type in “http://192.168.254.254”. This will launch the main status page for the Router that also
allows you to personalize your settings, such as your Wi-Fi name or password.
Note:
You will be asked to enter the Device Access Code (located on the bottom of the Router) if
you make changes to these settings.
Please also note any changes you’ve made to the router in the event you need support.
Home Wiring Connections
Frontier®uses an Optical Network Terminal (ONT) and a Router to connect your home to the Internet and enable Data, Voice,
and TV Services. If the steps above do not result in an Internet connection, you may be guided to check the cables on the ONT.
Ethernet-connected homes will require BOTH Ethernet and Coax connections from the ONT to the Router for TV service.
1Confirm the Coax connector on the ONT is securely connected to the
home wiring used by the router (or directly to the Router). Many ONTs
require this connection for both Data and TV services.
2Confirm the Ethernet connector on the ONT is securely connected to the
home wiring used by the router (or directly to the Router). Many ONTs
require this connection for Data services.
To determine if the ONT is provisioned for Ethernet or MoCA, look for the
light on the ONT:
- DATA light ON: Ethernet is provisioned.
- MoCA or HPNA light ON: Coax is provisioned.
Sample image, use actual
credentials on the router
Example ONT Image
Example Back of
Router Image
Example
Router Image
1
1
2
2
Sample image, use actual
credentials on the router
Don’t go it alone. CFI_UG_FiOS_0520_OL
To learn more about setting up your Frontier ID, managing your router and more, go to frontier.com/onlinehelp-fios
Troubleshooting
©2020 Frontier Communications Corporation. All rights reserved.
CFI_UG_FiOS_0520_OL
The FiOS marks are owned by Verizon Trademark Services LLC and used under license. Frontier is following applicable
CDC and state-required procedures to protect against COVID-19 transmission. Frontier is using its best efforts in this
regard. However, Frontier accepts no liability for illness related to installation or the provision of Frontier services. Frontier
also reserves the right to delay, postpone or cancel installation for reasons related to COVID-19 and/or state or local
rules, regulations or orders regarding COVID-19.
Problem: Internet light does not become solid blue.
• Solution: Make sure the WHITE Ethernet cable is connected to the RED Ethernet port on
the Router labeled “ONT Broadband” (not to the YELLOW Ethernet ports).
• Solution: Make sure the Coax cables are securely fastened to the Wall, Splitter, MoCA
Adapter and Router.
Problem: Unable to connect to Wi-Fi.
• Solution: Make sure you are selecting the Wi-Fi network printed on the sticker on the
bottom of the Router.
• Solution: Make sure you are correctly entering your Wi-Fi password
(password is case-sensitive, make sure Caps Lock is off).
Problem: Channel guide is not updating.
• Solution: Make sure the Coax cable is securely fastened between the Splitter and the
Router.
Problem: I have questions not covered in this guide.
• Solution: Please call the Frontier helpdesk at 1.800.921.8101.
• Solution: Videos and more information are available at frontier.com/helpcenter.
