ARTESYN EMBEDDED TECHNOLOGIES ATCA-9405 User manual

ATCA-9405
Quick Start Guide
P/N:6806800M81C (May 2014)
Observe ESD-safe
measures
What’s in the box?
When installing or servicing the
module or accessories, strictly
observe the safety precautions
in the Safety Notes. Otherwise,
personal injury or property dam-
age may occur.
• Use either a properly grounded ESD
wrist strap or make sure that you are
working in an ESD-safe environ-
ment.
• Connect to the ESD connector at the
front or the rear of the system.
Make sure you receive all items of
your shipment:
• ATCA-9405 blade
• Printed Safety Notes
• Any optional items ordered
Prepare the installation
site
• For information on the environmen-
tal and power requirements, see the
ATCA-9405 Installation and Use man-
ual.
• Operating temperatures refer to the
temperature of the air circulating
around the blade and not to the
actual component temperature.
1
23

ATCA-9405-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Finding more information
Visit our Web site http://www.artesyn.com.
Use the Product Search link to look for tech-
nical documentation.
Technical Assistance
To request technical assistance, visit our
Web site http://www.artesyn.com/com-
puting.
The following procedure assumes that the
system is powered. If it is unpowered, you
can disregard the blue LED and skip its
respective step.
1. Ensure that the top and bottom ejector han-
dles are in the outward position by squeezing
the lever and the latch together.
2. Insert the blade into the shelf by placing the
top and bottom edges of the blade in the
card guides of the shelf. Ensure that the guid-
ing module of the shelf and blade are aligned
properly.
3. Apply equal and steady pressure to the blade
to carefully slide the blade into the shelf until
you feel resistance. Continue to gently push
the blade until the blade connectors engage.
4. Squeeze the lever and the latch together and
hook the lower and the upper handle into the
shelf rail recesses.
5. Fully insert the blade and lock it to the shelf
by squeezing the lever and the latch together
and turning the handles towards the face
plate.
If your shelf is powered, as soon as the blade
is connected to the backplane power pins,
the blue LED is illuminated.
When the blade is completely installed, the
blue LED starts to blink. This indicates that
the blade announces its presence to the shelf
Install the Blade
Install the Blade (cont.)
4
Note: If an RTM is connected to the front blade,
make sure that the handles of both the
RTM and the front blade are closed in
order to power up the blade’s payload.
6. Wait until the blue LED is switched off, then
tighten the face plate screws which secure
the blade to the shelf.
The switched off blue LED indicates that the
blade’s payload has been powered up and
that the blade is active.
7. If necessary, connect cables to the face plate.
4
4