Artone PA-500R User manual

USER’S MANUAL
Mixing Power Amplifier
MAIN VOL BASS AUX 2 AUX 1 MIC 2 MIC 1 TREBLE
POW ER
ON
SIG
CLI P
M IX I N G P O W E R A M P L I F I E R PA - 5 0 0 R
MIC 2 IN MIC 1 IN
PA-500R

Mixing Power Amplifier PA-500R
page 1
Pre caution
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure that maybe of sufficient magnitude
to constitute a risk of electric shock to persons.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not cover any ventilation openings.
8. Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or the grounding-type plug.
10.Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11.Only use attachments/accessories specificed by the manufacturer.
12.Use only with the cart, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13.Unplug this apparatus during lightning storms or when unused for a long period of time.
14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
15.Do not expose this equipment to dripping or splashing and ensure that no objects filled with
liquids, such as vases, are placed on the equipment.
16.To completely disconnect this equipment from the AC mains, disconnect the power supply cord
plug from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.

page 2
Product Introduction
Features
Audio amplifier with 50W rated power;
8 ohm, 70V, 100V speaker output;
Small size and compact design mixer amplifier;
2 RCA external inputs and 1 audio output;
2 balanced XLR microphone Jack with Mic1 priority;
Volume control for treble, bass, main and MIC1/2;
Remote controller for volume level and mute;
Wall mounting or cabinet mount kit for easy and different application;
LED indicator for working status;
AC220~240V 50/60Hz power supply;
High temperature, over load, short circuit protection.
The mixing power amplifier PA-500R is a compact design mixer amplification device for 70/100V long distance
commercial audio system.
PA-500R external auxiliary audio RCA inputs and 1 out
It is designed in modern style with strong mounting kits for onwall installation conveniently, or place on the desktop.
the product made in reliable quality for commercial applications, and generate full range of frequency sound.
The amplifiers can be set as standalone audio system or part of large PA system, it is ideal to adopt for various
places like shops, supermarkets, restaurants, railway stations, theme parks, schools, hospital, etc.
include 2 put at rear side of amplifier, 2 XLR microphone
inputs allow speaking voice or notification deliver to people clearly, Mic1 features with priority than other inputs.
Mixing Power Amplifier PA-500R

page 3
1. Power ON / OFF switch
1. 8Ω speaker output
7. AUX1 volume control
2. LED indicators for Power, Signal and Clip 8. MIC2 volume control
3. Main volume knob and press to mute sound
11. MIC1 XLR input
10. MIC2 XLR input
9. MIC1 volume control
Front View
Rear View
1
4. Treble volume increase / decrease
5. Bass volume increase / decrease
6. AUX2 volume control
2. 70/100V speaker output
3. Audio signal output
4. AUX1 audio input RCA
5. AUX2 audio input RCA
6. Remote controller extension
7. Electronic fuse
8. Power supply AC100~110V 50/60Hz
Mixing Power Amplifier PA-500R
MAIN VOL BASS AUX 2 AUX 1 MIC 2 MIC 1 TREBLE
POW ER
ON
SIG
CLI P
M I X I N G P O W E R A M P L I F I E R PA - 5 0 0 R
MIC 2 IN MIC 1 IN
2
345678 9 10 11
AUX
OUTPU T
SP E A KER OU T PUT AUX 1
INPU T
AUX 2
INPU T
FUS E
AC IN
COMGND 70V 10 0 V
8
L
R
S
U
E
F
MOD E L: PA - 50 0 R
MIX I NG A M PL I FIE R
ANTENNA
L
R
12 3 4 5 6 7 8
Power Supply: AC220~240V 50/60Hz
Consumption: 80W
Fuse: 1A
Speaker Output: 70V/100V 8Ω

page 4
1. increase the volume
3. OFF / ON - mute all inputs
The remote is use for control the volume gain of amplifier from
10-20 meters, the control distance goes further when added
extension antenna on rear side of the amp receiver.
Remote Controller
Mounting Instruction
2. decrease the volume
Mixing Power Amplifier PA-500R
1
OFF / O N
)
)
)
)
2
3
AU X
OU TP UT
SPEAK E R O U T PUT AU X 1
IN PU T
AU X 2
IN PU T
FU S E
AC I N
CO MGN D 7 0V 1 00 V 8
L
R
U
S
E
F
MO D EL: PA -50 0R
MI X IN G A MPL IFI E R
AN TE NN A
L
R
Connect antenna to amplifier PA-500R with cable
SMA will make the device’s volume controlled
more stableand at further distance by remote
controller.
Bottom View
Use the wall mounting kits and screws comes along in the product package, to connect amplifier at the bottom.
Place the metal plate to bottom side of amplifier, use screws to fasten plate onto it. Leave the other 2 holes aside
from amplifier body, this is for installation on the wall or table cabinet.
Power Supply: AC220~240V 50/60Hz
Consumption: 80W
Fuse: 1A
Speaker Output: 70V/100V 8Ω

page 5
Input & Wiring Instruction
Given small and compact design, the mixing power
amplifier can be set on the desktop for sound system
directly with external audio inputs, it has features of
mounting on the wall or under the desk and table.
After mounting plate connected firm with amplifier,
use the screw driver to mount the amplifier through
2 spare holes on each mounting kit to wall or cabinet
vertically.
See demo as picture on the right side
Mixing Power Amplifier PA-500R
MAIN VOL BASS AUX 2 AUX 1 MIC 2 MIC 1 TREBLE
POW ER
ON
SIG
CLI P
M I X I N G P O W E R A M P L I F I E R PA - 5 0 0 R
MIC 2 IN MIC 1 IN
AUX
OUTP U T
SP EAK ER OU TPUT AUX 1
INPU T
AUX 2
INPU T
FUSE
AC IN
COMGND 70V 100V
8
L
R
S
U
E
F
MOD E L : PA -500 R
MIX I N G A MPL I F I ER
ANTE N N A
L
R
MIC ROP HON E
MIC ROP HON E
100V Loudspeakers
MAIN VOL BASS AUX 2 AUX 1 MIC 2 MIC 1 TREBLE
POWER
ON
SIG
CLIP
MI XI NG PO WE R A MP LI FI ER PA - 5 0 0 R
MIC 2 IN MIC 1 IN PC / DVD /
CD Player
Antenna
Dynamic Mic
Dynamic Mic
Preamp / Processor
Audio Amplifier
Power Supply: AC220~240V 50/60Hz
Consumption: 80W
Fuse: 1A
Speaker Output: 70V/100V 8Ω

page 6
Specification
Rated Power 50W
Inputs RCA AUX input x 2
Speaker Output 8 ohm, 70V, 100V
MIC Sensitivity Mic1/2: -50 dB balanced XLR jack / Imp. 20KΩ
T.H.D < 0.5 % (at 1/3 rated power)
S/N Ratio Mic: 70dB / AUX: 80dB
Control Treble, bass, main, AUX1/2, MIC1/2 volume
Remote
SMA-J / 50ΩAntenna Connector
Amp power cord 1.5m / Antenna cord 3.0 meter
Cable Length
Model No. PA-500R
Mixing Power Amplifier PA-500R
Protection
Power Supply
AUX Sensitivity AUX1/2: -30 dB unbalanced RCA jack / Imp. 10kΩ
Frequency Response 60~18KHz (±3dB)
10~30 meters
Amp 248 x 180 x 70 mm / Mounting Kit 180 x 50 mm
Measurement
Weight 5.2 kg
Short circuit, clip, over loading, thermal
AC 220~240V 50/60Hz
Material / Finish Metal / Black color
Accessories Amplifier, remote controller, antenna, mounting kit x 2, screws

Due to continuous improvement, the product may be updated without notification.
Thanks for your purchase !
Please contact our dealer or our company if
any information or assistance may needed.
Dealer:
www.ampspk.net