Aruba AP-220-MNT-W1W User manual

AP-220-MNT-W1W Wall Mount Kit
Installation Guide
0511288-04 | March 2015 1
1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2.
a. Install any necessary wall anchors. Wall anchors are not included in this kit.
b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated
screw points.
c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.
Figure 1 Attaching the Adapter to a Wall
Figure 2 Attaching the Adapter to a Wall (Alternate)
This mount kit supports multiple AP models. All installation images show the 225 AP.
AP-220_11
AP-220_14

©
2 AP-220-MNT-W1W Wall Mount Kit | Installation Guide
2. Attach necessary cables and/or antennas to the AP.
3. Attach the AP to the secured mounting adapter as shown in Figure 3.
a. Align the AP with a mounting adapter, placing the AP so that it’s mounting tabs are at an angle of
approximately 30 degrees to the adapter.
4. Pushing toward the wall, rotate the AP clockwise until it clicks into place (see Figure 3).
Figure 3 Attaching the AP to the Mounting Bracket
Figure 4 Completed Installation
AP-220_12
AP220_13