aslotel 9501M User manual

Page | 1
aslotel
relationship • experience • choice
ety information!
2200w 1 litre cordless kettle
Instructions for use
Product codes : E005447, E005449, E005454, E005455, E005500, E005501
Model no : 9501M & 9501F 220-240V AC 50/60Hz Ver.02/Mar 2016

Page | 2

Page | 3

Page | 4
For your safety
These operating
instructions contain
important safety
information together with
instructions on the proper
use of this appliance.
Read these instructions
carefully and in full, keep
them in a safe place and
pass them on to any
subsequent owner.
These safety instructions
are intended for your
safety.
This electrical appliance
complies with all relevant
EU safety regulations.
Always use the appliance
for the appropriate purpose
for which it was designed.
This appliance is intended
for heating water only.
Keep the appliance and its
cord out of reach of children
of less than 8 years of age.
This appliance can be
used by children from the
age of 8 up as well as by
persons with reduced
physical, sensory or
mental abilities or lacking
experience and / or
knowledge, only if these
persons are supervised
or have been instructed
how to use the appliance
safely and have
understood the hazards
which could arise from
using it. Children must
not play with this
appliance. Cleaning and
user maintenance must
not be carried out by
children unless they are
supervised.
Keep packaging material,
e.g. plastic bags, out of the
reach of children.
The appliance is only to be
used with the power base
provided.

Page | 5
Never remove the plug from
the wall socket with wet
hands or by pulling on the
supply cord.
Always disconnect the
appliance from the mains
supply and allow it to cool
down before cleaning and
maintenance or if faults
occur during operation.
The appliance is intended
for use in household and
similar applications
including :
staff kitchen areas in
shops, offices and other
working environments;
farm houses;
by clients in hotels,
motels and other
residential type
environments;
bed & breakfast type
environments.
Never immerse the
appliance or the power
base in water and never
use highly corrosive or
abrasive cleaning agents.
Safety instructions when
connecting the appliance to
the mains supply
DANGER
Risk of electric shock
To avoid the risk of electric
shock through contact with
live parts the following safety
instructions must be
observed:
If the electric supply cord is
damaged it should only be
replaced by a service
engineer appointed by the
manufacturer or distributor.
The voltage of the power
source must be the same
as that specified on the
rating plate.
Before use check that the
appliance functions
properly. The appliance
should not be used if:

Page | 6
the electric supply cord
is damaged
it shows signs of
noticeable damage
it has been dropped
CAUTION
To avoid the risk of personal
injury or damage to the
appliance always follow the
instructions for installation,
use and maintenance.
If you give the appliance to
another person then you
should also supply them
with the operating
instructions.
Connect the appliance only
to an AC supply. Do not pull
the supply cord over sharp
edges, clamp it in place or
allow the appliance to hang
by its supply cord. Keep the
supply cord away from hot
or damp areas
Never wind the supply cord
around the appliance.
Only insert the mains plug
when the appliance is
switched off.
The appliance is only to be
used with the power base
“g”.
Never place the kettle or
the power base “g” on or
beside hot surfaces, e.g.
cooking rings, gas burners,
radiators or similar.
If an extension lead is
required use only an
earthed supply cord with a
conductor cross section of
at least 1.5mm².
Safety instructions when
operating the appliance
WARNING
Do not use the
appliance near bath
tubs, showers,
basins or other
vessels containing
water.

Page | 7
DANGER
Risk of electric shock
Never use the appliance
with wet hands. Always
ensure that the power
base is dry and does not
come into contact with
water. If the power base
becomes wet remove the
mains plug immediately or
disconnect the fuse.
WARNING
Danger of burns from hot
components
The kettle will become hot
when in use. Contact with the
skin can cause burns. After
use always allow the
appliance to cool fully before
cleaning.
WARNING
Hot steam presents a
scalding hazard.
Hot steam emitted by the
kettle will cause scalding.
Observe the maximum filling
level. Never open the lid
during operation.
CAUTION
To avoid the risk of personal
injury or damage to the
appliance through improper
use always follow the safety
instructions.
Never place the kettle or
the power base “g” on or
beside hot surfaces, e.g.
cooking rings, gas burners,
radiators or similar.
The appliance is fitted with
a safety cut-out which turns
the kettle off in the event
that there is insufficient
water. If this happens
during operation wait 5-10
minutes before attempting
to use the appliance again.
The use of a residual
current device (RCD) rated
at 30mA or less will provide
extra protection against the
possibility of electric shock.
A qualified electrician will
be able to advise you.

Page | 8
Never switch on the
appliance when there is no
water in it.
Never fill the kettle beyond
the maximum filling level.
If the kettle is over-filled
there is a risk that it may
not switch itself off
automatically.
If the kettle is over-filled
boiling water may be
ejected through the spout.
The appliance becomes
hot during operation, this
is normal. Only ever use
the handle to pick up the
kettle and pour out the
water.
Protect the appliance from
direct sunlight or damp.
The appliance is not
approved or suitable for
use outdoors.
Do not place the appliance
or its supply cord on hot
surfaces, e.g. cooker, or
near naked flames.
Always disconnect the
appliance from the mains
supply and allow it to cool
down before cleaning and
maintenance or if faults
occur during operation.
Before use check that the
appliance functions
properly. The appliance
should not be used if:
the electric supply cord
is damaged
it shows signs of
noticeable damage
it has been dropped
Remove the plug from the
mains supply :
if the appliance does not
function properly
before cleaning
after every use.

Page | 9
Safety instructions for
cleaning and maintenance
DANGER
Risk of electric shock
There is a risk of electric
shock if the appliance comes
into contact with water.
Please observe the following
safety instructions:
Protect the kettle and
power base from damp.
Never immerse the
appliance in water and
never put it into the
dishwasher.
Never remove the plug
from the wall socket with
wet hands or by pulling on
the supply cord.
CAUTION
To avoid the risk of personal
injury or damage to the
appliance through improper
use always follow the safety
instructions.
Neither the kettle nor
power base contain user-
serviceable parts and must
not be opened.
For cleaning or
maintenance, or if faults
occur during operation,
remove the plug from the
mains supply and allow the
kettle to cool down fully.
Follow the instructions for
descaling.
Appliance specifications
Name: Cordless kettle with
power base.
Model no: 9501F & 9501M
Mains cord : Max. 1.0 m
Power supply: 220-240V ~ / 50/60 Hz
Rated input: 1850 W –2200 W
Filling level : Max. 1.0 litres
Heating system : Stainless steel element
Dimensions : 194mm(H) x 168mm(W)
Weight: Approx. 900 g
Protection
category: Class I (earthed)
CE compliance: The appliance complies
with EU Directives EMC 2004/108/EC and
Low Voltage 2006/95/EC.
f

Page | 10
Parts
a. Safety Locking lid
b. Lid opener
c. Heating control lamp (red)
d. Handle
e. Water level indicator
f. ON / OFF switch
g. Power base with supply cord storage
compartment
h. Scale filter (washable)
Intended use
The appliance is only intended for boiling
water. Never put milk, soup, coffee, tea or
rice, etc. into the kettle.
No liability is accepted for any damage
resulting from use for any other purpose or
unauthorised repairs. Warranty is void for
damage or failure caused by negligence or
misuse.
The kettle is not intended for catering
purposes.
AIRER
Initial use & operation
FIG. 1
Before using the kettle for the first time fill it
up to the maximum level (1.0 litres) and boil
it. Rinse the kettle with clean water and
repeat.
Method
Adjust the required length of supply
cord on the power base “g”. Wind
excess cord into the base and guide
through one of the recesses.
Connect the power base “g”to the
mains supply following the relevant
safety instructions.
Operate the appliance according to
the instructions below (1).
Using the kettle
FIG. 2 - 8
Filling with water
Open the lid “a” with the lid opener “b”
and fill the kettle (2, 3).
Check the filling level on the water level
indicator “e”. Note the maximum filling
level (4).
Note
If the kettle is accidentally started empty, the
safety cut-out will automatically switch it off.
In this case you should remove the kettle
from the power base and allow it to cool
down fully. Make sure that there is water in
the kettle before using it again.
Switching on
After filling close the lid “a” securely
making sure it is locked in place (5).
Position the kettle on the power base
and connect the power base “g” to the
mains supply (6).
Note
If the lid is not closed properly the kettle will
not shut off automatically.
Switch on the kettle using the on / off
switch “f”. The heating control lamp “c”
will illuminate (7).
Note
The on / off switch only operates when the
kettle is positioned on the power base.