ASROCK iBOX-220 User manual

Inside View
Front View
Rear View
iBOX-220
Quick Installation
Guide
P/N: 15G06M034000AK V1.0
Front Panel
Rear Panel
SO-DIMM socket
M/B
mini-SATA slot
mini-PCIe slot
2 x USB 2.0 Ports2 x COM Ports
HDD LED
Power LEDOn-/off Switch
DC IN2 x LAN RJ-45 PortsLine out
Kenshington Lock
Antenna Port Microphone Antenna Port
HDMI
VGA 2 x USB 3.0 Ports
*15G06M034000AK*

1. Removing the Bottom Cover
6. Replacing the Bottom Cover
2. Installing the SO-DIMM
3. Installing the Hard Drive
4. Installing the WiFi module
Note
1. Remove the four screws on the boom case.
2. Li up and remove the top cover.
3. Aach one end of the SATA 1 to 1 Power Cable
to the hard drive.
4. Aach the SATA data cable and power cable
to the motherboard.
1. Aach the HDD onto the boom cover with
the printed circuit board side facing down.
Carefully align the mounting holes in the hard
drive and the boom cover.
2. Secure the hard drive into the place using the
four screws.
1
2
2
2. Insert the RP-SMA Wi-Fi Antenna Connectors
to the antenna ports on the rear panel.
en fasten the screw nuts to secure the antenna
connectors.
2. Connect the two WiFi 2.4/5 GHz Antennas to
the antenna connectors. Turn the antenna
clockwise until it is securely connected.
3. Set the WiFi 2.4/5 GHz Antenna at 90-degree
angle.
*You may need to adjust the direction of the
antenna for a stronger signal.
1. Replace the top cover.
2. Secure the four screws at the boom.
For more details on the hardware installation,
please refer to the User Manual in the support CD.
*is step is optional.
5. Installing the WiFi antennas
*is step is optional.
1. Insert the WiFi Module Card into the mini
PCI Express slot (MINI_PCIE1).
2. Tighten the screw that holds the card in place.
1 Aach the SMA Wi-Fi Antenna Cables to the
WiFi Module.
SATAII_1
SATA Power Output Connector
e terms HDMI™ and HDMI High-Denition
Multimedia Interface, and the HDMI logo are
trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other
countries.