Assured PERFORMANCE ACHRYH-7638 User manual

Assured Performance-PN: ACHRYH-7638
1. Mount siren speaker facing downward in Engine compartment of vehicle. Mount in an
area were siren speaker will not get submerged in water. Mount siren speaker at least
14” from battery.
2. Connect RED wire from Siren to a toggle switch circuit (option 1) or a POSITIVE 12V
ignition source (option 2). Using inline fuse is recommended.
3. Connect the BLACK wire to a GROUND or Negative Battery Post.
4. Run the microphone lead wire inside the cab of vehicle.
5. Plug microphone coiled wire into microphone lead wire (similar to a phone jack). Plug
microphone in BEFORE connecting the 12v power source.
The reason you want to use a toggle switch or connect via an ignition source is because
speaker will draw micro amps even when not in use. It may drain you battery after time.
Trouble Shooting
Problem: Siren is not working, not making any noise at all.
Solution: (1)Check the fuse. (2)Be sure you have 12v going to the red lead on speaker. (3)Be
sure toggle switch (if using a toggle) is in “ON” position. (4)If using ignition source, be sure
ignition is in “ON” position.
If all above is good, and still no sound from siren speaker. Hook siren leads directly to 12v
battery. If still issue, Call Us.

Problem: When power is “ON”, speaker ‘clicks’, but sirens sound(1 or all) do not work.
Solution: (1)Be sure microphone plug is secure. It should ‘click’ into a lock position.
(2)Disconnect plug, check the prongs on female side of plug to be sure all are straight. Re-plug
and test.
If all above is good, and still no sound from siren speaker. Hook siren leads directly to 12v
battery. If still issue, Call Us
Problem: Siren Speaker sequel or hollows when using PA.
Solution: You are getting feedback through the speaker. This happens when speaker is
microphone is getting a frequency from a alternative power source. (1)Be sure the speaker is
not mounted near the 12v source. (2)Be sure supply wire from siren speaker to microphone is
not wrapped around a 12v source wire. (3)Be sure microphone is not near a 12v source in
vehicle cab. (3)Be sure microphone is at least 25” from speaker. (4)Be sure microphone supply
wire from speaker is not coiled up near the speaker.
If you have any further issues, feel free to call us: Phone [phone]