Astonica 50104227 User manual

Model No. 50104227
Sun Shelter Gazebo - 8' x 8'
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
261110rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
®
Made in China
©2010 World Factory, Inc.
Distributed by:
World Factory, Inc.
Westlake, TX 76262
For warranty information, please refer to the back page of
this instruction manual.
Limited Warranty
World Factory, Inc. Products for Home Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service
center. Call 1-888-422-7800 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF
PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This warranty gives you special legal rights, and you may also have other rights which vary from state
to state.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.

1 Tube 1 4
2 Tube 2 4
3 Tube 3 8
4 Tube 4 4
5 Tube 5 4
6 Tube 6 4
A Vertex Connector 1
B Corner Connector 4
C Corner Tube Base 4
D Cover 1
E Steel Stakes 8
F Tie-Down Rope 4
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
3
2
3
3
3
3
4
4
3
5
5
5
5
3
4
4
56
1
1
ABC
A
B
B
DF
Figure 4
Figure 5
Figure 2
Figure 3
Figure 1
12
1. (SEE FIGURE 1) Place the 4 corner connectors (B)
about 9.75 feet apart forming a square. Line the
sides of the square with tube 3 (3) and tube 4 (4)
as shown in figure 1.
Note: Each tube should have a number sticker on
the tube.
Connect the tubes together and then connect the
tube assemblies to the corner connectors (B).
2. (SEE FIGURE 2) Connect tube 1 (1) to tube 2 (2)
forming 4 roof tubes. Connect the roof tubes
to the vertex connector at tube 1 end, and then
to the corner connectors at tube 2 end.
Connect tube 5 (5) to the bottom of the corner
connectors (B) as shown in figure 2.
3. (SEE FIGURE 3) Put the cover (D) and spread
it over the roof assembly.
4. (SEE FIGURE 4) Connect tube 6 (6) to the
bottom of tube 5 (5) ensuring the row of holes
in tube 6 are at the bottom. Connect tube 6 (6)
to the corner tube base (C) at each corner.
5. (SEE FIGURE 5) Pull the cover tightly over
each corner of the frame. Use the hooks,
located at the bottom of the cover corners,
to secure in the first hole at the bottom of
tube 6. If the cover becomes loose during use,
reposition the hook into the next hole down.
Secure the corner tube bases (C) to the ground
using the steel stakes (E) through one of the
holes in the base. Secure the gazebo shelter to
the ground using ropes (F) and stakes (E) at
each corner as shown.
3
3
4
2
2
2
2
11
1
1
6
6
6
3
56
4
2
B
B
B
Parts Detail
Note: Choose a flat level area for easiest and fastest
assembly of the gazebo.
B
B
B
E
D
C
C
C
F
F
F
F
E
E
E
E
E
C
6