Asus Aaeon UP Core AL User manual

1
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Assembly SOP EP-CHUPCMTVAUPC
UP Core AL Chassis
Exploding View:

2
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Parts List
The kit includes the following items:
•Heatsink top cover @1pc
•Middle base @1pc
•Bottom @1pc
•Thermal Pad @4pcs
•VESA Mount/Din Rail Plate @1pc
•M2.5*6 screws. @4pcs
•M2.5*8 screws. @4pcs
•Hex Standoff @4pcs
•Din rail screws kit M3*6@1pcs & M3*8@2pc
•Vesa screws- Pan screw M3*8 @4pcs
•SMA plug @1pcs
Not included with the kit, you may need to prepare:
•UP Core board
•Din Rail Clip 20mm

3
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Package of main housing:

4
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Package of Din Rail /VESA Plate:

5
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Assembly main housing:
1. In order to start with the assembly of your UP Core Metal Housing, start by first removing the
heatsink from the motherboard. The following link provides a overview on how to remove the
heatsink: https://wiki.up-community.org/How_to_remove_heatsink
The picture below shows the result of the heatsink removal.

6
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
2. Place the heatsink top cover upside down and stick the thermal pads on the four blocks with the
blue films facing up.
3. Peel of the blue films of the thermal pads.

7
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
4. Re-assemble the heatsink top cover with the middle base first.
5. Carefully place the UP Core board on the 4 studs, and press the board softly into its place.

8
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
6. Fasten the UP Core Board to the top cover with the hex standoffs through the thread nuts.
7. Place the bottom base on the middle base and fasten it with the M2.5*6 screws.

9
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
8. Check if the sides exactly match the IO sides.
9. The finished chassis:

10
©AAEON Europe BV –Confidential –All Rights Reserved
06/02/18
Optional: Assembly main housing with Din Rail/VESA Plate
1. In case you will use the VESA Plate, you will need to replace the M2.5*6 screws mounted in the
housing and replace them for M2.5*8 screws, which are in the Package of the Din Rail / VESA
Plate.