ATHY CM-DK6848 User manual

Attach legs (#2) to the bottom holes of the cabinet body (#1).
Attach 4 wood dowels (#G) to each riser (#4),
then attach the risers (#4) to the holes of the
bottom plate (#3) as shown in the picture.

Insert barrel nuts (#B) to the holes of the bottom plate (#3). Make sure the barrel nut (#B) holes are facing the
same direction as the hole on the back side of bottom plate (#3). Align backplane (#5) to the holes of the
bottom plate (#3), then secure by attaching bolts (#A) to barrel nuts (#B).
Align the panel (#6) to the holes and wood dowels of the rest of the cabinet. Insert barrel nuts (#B) to the holes
of the backplane (#5) and make sure the barrel nut hole is facing upwards. Secure by attaching bolts (#A) to the
barrel nuts (#B).

Prepare 4 bolts assembly by inserting lock washer (#D), then flat washer (#E) onto bolts (#C). Align mirror
connecting rods (#10) to the holes located in the back side of the cabinet body (#1). Secure with bolts (#C).
Prepare 4 bolts assembly by inserting lock washer (#D), then flat washer (#E) onto bolts (#C). Align mirror (#8)
to the holes of the mirror connecting rod (#10), then secure with bolts (#C).

Slide the side mirrors (#9) down to the metal pole of the middle mirror (#8).
Unscrew the knob, then reattach the knob to the outside of the drawer.

Prepare 8 bolts assembly by inserting lock washer (#B), then flat washer (#C) onto bolts (#A).
Align legs (#2) to the holes of the cushion (#1), then secure with bolts (#A).