ATOLL ELECTRONIQUE
OWNER’S MANUAL ~ PHONO PREAMPLIFIER PH100
ATOLL ELECTRONIQUEPage 3Page 6
CAUTIONS
ADVISES
E.C. marking certified the conformity with low tension directive 73/23/CEE, directive
CEM 89/336/CEE and national transpositions.
E.C. MARKING
Before any cleaning, switch off your amplifier (6). Use a soft and dry rag to clean up
the appliance. Never use acetone, white-spirit, ammoniac, or any kind of product
containing abrasive agent. Never try to clean up inside the appliance.
The guarantee is two years period from date of purchase. We recommend you to ask
your dealer to fill the guarantee and to conserve it. The guarantee is only available
for appliance which have been use correctly.
CLEANING
WARRANTY CONDITIONS
(*)
Depending on the position of the switches.
(Data subject to change)
• Do not make any connections when your device is powered on.
• Put your device in a dry and well ventilated place, far from a source of
heat
• Avoid putting something on your amplifier.
• Do not make any plug-in when the converter is on.
• Avoid any short-cut.
• Strictly respect polarity +& , as well as the left and right connections.
• Your device will offer you optimal listening quality approximately half an
hour after it is powered on, until the stages reach their ideal operating
temperature.
• At night or when you leave your home it is best to use the main switch to
turn off the device.
• We advise you to choose good quality connection cords (to other
devices). Do not hesitate to seek advice from your specialist retailer.
PHONO PH100 MODULE
Power supply :
Total of capacitors :
Switch OFF consumption:
ON consumption:
Type of cartridges:
Input impedance:
Input capacity:
Gain MM :
Gain MC High-level:
Gain MC Low-level:
Signal-to-noise ratio at 1 kHz:
Crosstalk at 1 kHz:
THD:
Size:
Weight:
6,4 VA
11 280 µF
0 W
4 W
MM / MC
47 k or 100 k(*)
100 pF or nothing(*)
40 dB(*)
47 dB(*)
60 dB(*)
80 dB
<-85 dB
0,05 %
320×210×63 mm
2 Kg
