Audioplex RCLL-1L User manual

RCLL-1L
The RCLL- line level remote control is a versatile means of controlling
a line level source.
The level may be controlled three ways: From a remote
location using an infrared repeating system, using the included IR eye, or
manually at the front of the unit.
1L
the volume of It typically connects between the source
and an amplifier.
with a knob It has the ability to learn
commands for volume up, down, and mute from most consumer remote
control units (not included). It is powered by a supplied 12 volt power
adaptor.
INSTALLATION
Follow the wiring diagram on the back of this sheet, using RCA cables (not included) for the RCLL-1 to the
source and amplifier. To use a remote control in the same room as the RCLL-1, plug the included IR eye into the
jack on the back of the unit, and mount it in a location where it can see the remote. To connect an optional infrared
repeating system, connect the signal and ground wires of the system to the binding posts, paying attention to
polarity: signal to red, ground to black. Set the volume control on the front to about mid range, then connect the
included power supply to the jack on the rear and plug it into an AC outlet.
TECHNOLOGY INSTALLATION MANUAL
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 603-544-8601 FAX: [phone]
www.audioplex.com
AUDIOPLEX TECHNOLOGY
2012 1/3/12
Learning Remote Controlled
Line Level Volume Control
OPERATION
When the unit is powered up, the volume will be at .
The RCLL-1 will respond volume up, volume down, and mute commands .
Holding either volume button on the remote will cause the unit to continuously change volume.
knob to the maximum volume
a reduced volume, then increase to maximum after 5 seconds
to programmed into the RCLL-1L
The front may be used limit . It is not controlled by the remote.
PROGRAMMING
The RCLL-1L is preprogrammed to work with Proscan amplifier commands. If you have a remote that can send
these commands, skip to the section on OPERATION.
To program the RCLL-1L for specific remote commands, first decide what keys on your remote you want to use
for Volume Up, Volume Down, and Mute. They probably shouldn’t be buttons you use for another device so that
commands meant for that device won’t control the RCLL-1L and vice versa.
To place the RCLL-1L in learning mode, disconnect the power from the back of the unit, get your remote ready,
and plug the power back in. Within 5 seconds press the key for volume up, volume down, mute, volume up
(again), volume down (again), and Mute (again).
Learn mode is indicated by a lowered volume level, and will cancel if:
You take longer than 5 seconds to press the next key
The key sequence is wrong, such as a key held down too long and registered twice
The volume up, volume down, and mute sequence isn’t repeated
If you have problems after several tries at programming, your remote (or function keys) may be incompatible.
Try a different key, mode, or remote.
Learned commands (including factory programmed Proscan commands) are saved until new commands are
programmed.
For more help or information, contact Audioplex technical support at 800-257-2077 or [email protected].
Test your keys for proper function. If they don’t work as desired, repeat the learn process.




AUDIOPLEX TECHNOLOGY
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 603-544-8601 FAX: [phone]
www.audioplex.com
WARRANTY
Your AUDIOPLEX TECHNOLOGY RCLL-1 is covered by a LIFETIME WARRANTY against any
defects in workmanship and materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused by abuse or by
modification or service by any unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any
necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The products must be returned expenses
prepaid, with written authorization from the company. The product must be shipped with the proof of purchase
and in the original carton and packing material to avoid damage.
2012 - 1/3/12
WIRING DIAGRAM
12 VDC
FROM IR
REPEATING
SYSTEM 12V POWER
SUPPLY
OPTIONAL
IR EYE
IR
EYE
LINE
IN
LINE
OUT
FROM
SOURCE
LINE OUT
TO AMP
LINE IN
APPLICATION NOTE
Many modern TVs have a fixed audio level from their line level outputs. Using these TVs with an
external amp means that the TV’s remote no longer works.
Install the RCLL-1L between the TV and the amp, and program it to respond to the TV’s Volume
and Mute remote commands to restore this function.