WARNING: TO REDUCE THE
RISKOFELECTRICSHOCK,DO
NOT REMOVE COVER (OR
BACK)NOUSER-SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash
andarrowheadwithin
the triangle is a
warning sign alerting
you of "dangerous
voltage" inside the
product.
Theexclamationpoint
withinthetriangle is a
warning sign alerting
you of important
instructions
accompanying the
product.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
PORTABLE CD SYSTEM
OPERATINGINSTRUCTION
Should any trouble occur, disconnect the AC power cord and refer
servicing to qualified personnel.
SAFETY PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
•Do not use the unit in places which are extremely hot, cold, dusty or
humid.
•Place the unit on a flat and even surface.
•Do not restrict the air flow of the unit by placing it in a place with poor
air flow, by covering it with a cloth, or by placing it on a carpet.
ON SAFETY
•Whenconnecting and disconnectingthe AC cord,grip the plugand not
the cord itself. Pulling the cord may damage it and create a hazard.
•When you are not going to use the unit for a long period of time,
disconnect the AC power cord.
ONAC VOLTAGE
•Beforeuse, check thatthe rated voltageof your unitmatches your local
voltage.
•When there is condensation inside the unit, the unit may not function
normally.
•Let it stand for 1 to 2 hours before turning the power on, or gradually
heat the room up and dry the unit before use.
FCCINFORMATION (for USA)
Thisdevice complies withpart 15ofFCC Rules.Operationsare subjectto
thefollowingtwoconditions:
(1) Thisdevicemay not cause harmfulinterference,and
(2) This device must accept any interference received, including
interferencethat may cause undesirableoperations.
RATINGPLATE LOCATION
The rating plate location is on the bottom of product.
This product contains a low power laser device.
CLASS 1 LASER
PRODUCT
CLASS 1 LASER PRODUCT
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
SPECIFICATIONS
GENERAL
Power consumption: 12 W
Powersource: AC 120V~60Hz(USA andCanada)
AC220V ~50Hz(China)
AC220V~60Hz(Korea)
AC230V~50Hz (Europe and Hong Kong)
AC240V~50 Hz(Australia)
AC110-120V/220-240V~50/60Hz(Others)
DC 9V (6 x "C" size or UM-2 batteries)
Specifications subject to change without notice.
TROUBLE SHOOTING TIPS
CD
Problems
System does not turn on
Disc in place but unit
won't play
RADIO
Problems
Poor FM reception
Poor AM(MW) reception
Solutions
•Make sure AC power plug is secure in
the outlet and inlet has power.
•Batteries may be dead. Install new
batteries.
•Make sure the FUNCTION switch is set
to CD position.
•Make sure disc is clean and undamaged.
•Make sure printed side of disc is facing
up.
•Make sure PAUSE mode is not activated.
•Make sure the unit is on a secure spot.
Vibration or jarring can cause the disc to
skip.
Solutions
•Electrical interference in your home can
causepoor reception. Movetheunit away
from them (especially those with motors
and transformers).
•Reposition or turn the unit for better
reception.
CARE & MAINTENANCE
HANDLING THE COMPACT DISC
It'simportantthatyou periodically clean the laser lens:
1. Turn off the unit's power and disconnect the AC
power.
2. Open the CD door and remove the disc.
3. Clean the lens with a soft cloth or use an air blower
brush designed for cameras.
4. If you still are not able to remove dirt particles,
moisten a cotton swab with isopropyl alcohol and
gently apply to the face of the laser lens, rubbing
gently until all traces of dirt are removed.
GENERAL GUIDELINES
•Do not touch the laser lens on the CD player.
•Temperature changes can cause condensation to form on the laser
lens. If condensation forms on the lens, leave the disc compartment
door open (without disc) for an hour to remove condensation.
•Exposure to direct sunlight or extreme heat (such as inside a car
parked in the sun) can cause damage or malfunction.
•To prevent dust from reaching internal parts, keep the compartment
door closed when not using (except when necessary to remove
condensation).
Laser lens
Althoughthemusic tracks in the disc arecoveredwith
a protective layer, it is still advisable to treat the disc
carefully. Always pick up discs by the edge and put
them back in their holders immediately after use.
IMPORTANT NOTICES:
•Should the CD door be opened before the reading of the CD is
completed,a jammingnoise mayoccur.This canbe resolvedbyclosing
the CD door and then sliding the FUNCTION switch temporarily to
OFF.
•If an abnormal display indication or an operating problem occurs,
disconnect the AC power cord and remove the batteries. Wait at least
5seconds,then reconnect theACpower cord orreinstallthe batteries.
CLEANING THE UNIT
Donotuse volatile chemicalsonthis unit. Clean bylightly wiping with a
soft cloth.
811-138191-030 Printed in China