Audiovox DVDMP User manual

INSTALLATION INSTRUCTIONS
DVDMP
DIGITALVIDEO DISC MOUNTING PLATE
TOOLS REQUIRED:
1. Power Screw Gun or Drill
2. ¼” Nut Driver Attachment for Screw Gun
INSTALLATION:
1. Locate a flat surface in vehicle. *Depending on vehicle, the surface can be under a seat,
rear cargo area if Sport Utility Vehicle, or trunk of passenger car.
2. Take notice of any obstacles under mounting surface, such as a harness under a rug, fuel
lines, or a fuel tank under the vehicle that might be damaged by mounting of DVDMP.
3. After locating an area to mount plate, place DVDMP down on location and align the plate
so there is one mounting hole located in the front and 2 mounting holes in the rear.
4. Using Screw Gun and Nut Driver Attachment, secure DVDMP with one washer and one
screw in each mounting hole. Tighten down all 3 screws.
5. Re-check area under mounting plate to confirm mounting screws did not damage any
components under the plate.
6. Route LED Repeater wire under the DVD, making sure wire does not get pinched.
7. Remove adhesive backing from the adjustable, beveled repeater cup.
8. Place LED repeater in adjustable cup, making sure LED repeater is secured to adhesive
pad.
9. Place DVD on plate and align LED repeater with IR window on DVD unit.
10.Install wiring to DVD as noted in Instruction Manual included with DVD unit.
11.Secure DVD by connecting the two ends of plastic strap. Pull loose end of strap to
tighten down unit securely into mounting plate.
© 2000Audiovox Corporation, Hauppauge NY11788 128-5841