Australian Pump Industries Clean Air VC44 User manual

NEW AUSSIE CLEAN AIR
VC SERIES
Industrial Wet/Dry
FREE
AUSSIE MICROWEB
99.9% FILTRATION
Clean Air VC44
Clean Air 752 (VC72)
Clean Air 753 (VC73)
Clean Air Jumbo (VC83/3)
Clean Air Drum Vac
ATTENTION: Operators must read this manual and understand it completely before
using the machine.
MAY 2015
WARNING: NOT FOR USE WITH ASBESTOS MATERIAL

2 Aussie Eco-Clean Industrial Wet/Dry Vacuum Cleaners May 2015
NEW CLEAN AIR MODELS VC44, VC72, VC73,
VC83/3, DRUM VAC
Congratulations on choosing an environmentally friendly Aussie Eco-Clean Product.
FREE AUSSIE MICROWEB FILTER….Its unique filter media is constructed from a homopolymer acrylic fibre
with a microporous membrane applied to the collection surface. This provides a low pressure drop, improved dust
caking, better dust release and improved collection efficiency.
Microweb is used with dust from limestone, biochemical, lead, sugar, cement precious metals, pigments & fertilizers.
IMPORTANT
Before starting to use the machine, please note the following points and read these safety
instructions.
▪If you should discover any damage when unpacking the machine, please inform your Aussie Eco-
Clean Distributor.
▪Certain parts may be packed in the tank to protect them from damage. These should be removed
before the cleaner is put into use.
▪The supply voltage must be 240V.
1. SAFETY INSTRUCTIONS
1.1 Recommended Usage
This machine is designed for professional cleaning according to these instructions, in particular for
the removal of types of dust which may be dangerous to health (not asbestos material).
1.2 General Safety Instructions
This machine is designed and constructed using state of the art protective devices. Danger can
occur in spite of this, particularly in the case of careless operation or non-compliance with these
safety instructions.
Danger –Electrical voltage/electric current
Contact with electrical current carries the risk of electric shock with can result in serious injury or
even death. Never touch damaged cables. Always switch off and disconnect the power supply
before carrying out any work on the machine. Replace faulty cables immediately.
1.3 Improper Usage
Any usage of the machine for a purpose not covered under the “Recommended Usage” or
previously agreed in writing is not permissible. The use of the machine in an unserviceable
condition or not in compliance with the following is prohibited:
▪Protective devices must not be removed or bypassed.
▪Any conversion or modification of the machine is not permitted.
▪Defective supply cables are only to be replaced by original cables.
▪Coupling elements between mains supply and/or extension leads must be at least splash-
proof.
▪The machine is to be fitted with a 10amp rated plug for use with 1 or 2 motors and 15amp
rated plug for 3 motors.
▪Fabric filter must be in place in tank for dry vacuuming.
1.4 Operator Responsibility
It is the responsibility of the operator to ensure that:
▪The machine is used only by personnel who have been instructed in its handling and who are
authorised to use it.
▪The recognised occupational safety regulations are observed.
▪Any further national or internal company regulations are observed.
▪All users are acquainted with the safety regulations and trained in the use of the specific
machine.
▪Responsibility for the operation, maintenance and repair of the machine is clearly assigned
and observed.
▪Faults and damage are immediately notified to the Authorised Service Agent
▪The operator is advised to wear proper soled footwear when using the unit.

May 2015 Aussie Eco-Clean Industrial Wet/Dry Vacuum Cleaners 3
1.5 In The Case Of An Emergency
▪Pull out the mains connector plug.
▪Immediately apply recognised first aid measures.
▪Do not resume operation until machine has been checked by a qualified technician.
1.6 Electrical connection and supply
▪240 volts.
WARNING –This appliance must be earthed!
1.7 Warning
▪Do not collect dust that may contain asbestos material with this machine.
▪The cleaner should never be used for picking up hot ashes, explosive fluids or undiluted acids
or solvents. These include petrol, paint thinner and heating oil, all of which can generate
explosive mixtures or vapours when mixed with the suction air. Acetone, undiluted acid and
solvent may damage the materials of the machine.
▪For cleaning or servicing the machine or when replacing parts the motor should be switched
off and the electric plug be withdrawn from the socket.
▪Care should be taken to ensure that the electric cable is not damaged by being driven over,
crushed or strained. Care should also be taken to ensure the electric cable is not pulled
through pools, water or spills.
▪Check electric cable regularly for any signs of damage, ageing or fraying.
▪The machine must not be used if the electric cable is not in a proper condition.
▪It is advised when using equipment that earmuffs be used during operation of the unit.
▪Do not hose down the vac head as water may enter the unit and damage the motors.
▪When using your machine for wet use only ensure that the fabric filter is NOT installed in the
recovery tank.
▪Never allow the liquid to exceed maximum level in recovery tank; i.e. when the float inside the
machine rises to the vacuum cleaner head causing suction to be cut off, immediately empty
the recovery tank.
▪For dry use the fabric filter bag must be fitted to protect motor.
2. OPERATION
2.1 Assembling Your Machine
▪Open the clasp and lift off the suction head.
▪Take the accessories out of the tank if they are packed this way.
▪Replace the suction head on the tank and close the clasp.
2.2 Preparation For Use
▪Fit the hose into the suction hose connection until it clicks.
▪Assemble the suction tubes and fit to the hose.
▪Fit correct accessory to suction tube.
2.3 Filter Usage
▪Fit fabric filter in tank for suction of dry dust.
▪Remove fabric filter from tank for suction of liquids if your machine is a wet/dry model.
2.4 After Use
▪Empty tank after use.
▪Shake filter bag to dislodge dust before removing from tank.
NB. Vacuum cleaners with 2 or 3 motors can be used with 1 or more motors.
3. NORMAL CARE & MAINTENANCE
ATTENTION: Remove plug from socket before any maintenance operation on
the head of the machine.
▪Clean the machine inside and outside.
▪Check the filter bag for holes or signs of wear and tear to avoid microscopic particles entering
your motor.
▪Empty and clean filter bag after every use. NB. If you clean the filter with water, ensure that it
is dry before you replace it.
▪Clean the rubber which is in the cover of the head.
▪Check the hoses and the electric cable.
▪We recommend that the carbon brushes on your motor are replaced every 200 hours.

4. ACCESSORIES
CLEAN AIR VC44, VC72, VC73 42mm diameter
Pos Description Part #
Complete accessories kit VAK40MM
A Flexible crush proof hose (3m) VHOSE38MMX3
B Chrome wands (650mm) Male: VHH012M
Female: VHH012F
C Crevice tool VLL002N
D Round brush VZZ061
E Hard floor brush with swivel (420mm) VKS011
F Squeegee with swivel (420mm) VKS013
G Accessory adaptor VAD001
Optional accessories
Aluminium carpet brush with swivel VKS012
I Outrigger (650mm) with mounting bracket VKA011
38mm hose cuff (hose to tank fitting) VEE004N MICROWEB Micro Filters
38mm hose tail (hose to wand fitting) VEE005N (99.9% filtration) for a healthier clean:
38mm hose jointer V69052 To suit C44 VKF055
Paper bag to suit VC44, VC72 VC73,, V44715 To suit VC72, VC73, VC83/3 VKF056
VC83/3 (1 only)
Rubber squeegee to suit VKS013 (set of 2) VLA013 Complete replacement heads:
To suit VC44 VKE012
To suit VC72
To suit VC73
CLEAN AIR VC83 JUMBO
Standard tools - 50 mm P/N VK0100
Pos Description Part #
Complete kit VK0100
A Flexible hose assy 3m VKT005
B Extension-chromed steel VHH005
C Crevice tool VLL003
D Round Brush VZZ101
G Floor tool VZZ091
H Accessory adaptor VAD002
Standard tools - 90 mm P/N VK0101
Complete kit VK0101
A Flexible hose assy VKT006
B Extension tube VHH019
C Suction end VLL005
Filter (3 micron) VKF006
5. TROUBLESHOOTING
Fault
Cause
Remedy
Motor (suction turbine)
No electrical power.
Check fuse, cable, plug and socket.
Suction slowly decreases
Filter, nozzle, suction hose or
extension tube blocked.
Check and clean.
Suction suddenly decreases
The filter is clogged with dust or
tank is full.
Switch off the cleaner, clean
filter/empty tank.
Dust escapes when cleaning
Filter incorrectly fitted or defective.
Check filter sealing. Replace filter.
Theelectricalcomponentsmayonlybecheckedandservicedbyanelectrician.
Formoreseriousproblems,pleasecontactAussieEco-Cleancustomerservice.
WARNING
Fine dry powders like cement, gyprock dust, talcum powder or materials of similar consistency can cause clogging of
filter with resulting overheating of the machine and possible motor burn outs.
We suggest for handling materials of this type a Microweb filter, used in conjunction with a suitable Aussie Eco-Clean
paper bag vacuum cleaner insert, should be used. This will help to protect your machine. Please note, overheating
caused by handling fine dust as described above is not covered by your machine’s warranty.
Full spares breakdowns are available at www.aussiepumps.com.au
AUSTRALIAN PUMP INDUSTRIES
7 Gladstone Road, Castle Hill NSW 2154;
Ph: [phone] Fax: [phone]
Email: [e-mail]
Website: www.aussiepumps.com.au
AB
GCDH
ACB
I