Components
A Rods
B
Rod
Adjustment
Clamp
C Keyhole
Locking Disc
D 3/8” BSW
Fixing Hole
E 1/4” BSW
Fixing Hole
F Camera
Screw
Assembly
A
B
F
C
E
D
1. Assemble the Gold Plate
by screwing the extension
rods into the rear of the Gold
Plate. (A)
A
6. Mount the camera using the camera screw ensuring
that the lens is in the centre of the aperture on the back
of the hood. To adjust the height of the hood loosen the
tube clamps, adjust to the desired height and retighten
to secure. The hood and bracket assembly can be
moved forwards or backwards by loosening the rod
adjustment clamp, once in the desired position retighten
to secure.
7. If needed the height of the entire bracket assembly
can be adjusted by using the alternative holes in the key
hole plate. Two positions are available. To move the
plate remove the screws and re-fix using the alternative
holes.
5. Ensure that the bracket
set is secured in position
by tightening the keyhole
locking disc.
4. Mount the hood and
bracket set onto the rods
using the keyhole mounting
holes.
3. Replace the Gold Plate
on the tripod head
ensuring that the keyhole
locking discs are facing
forward.
2. Remove the hot shoe
from your tripod head
and fix it to the
underside of the Gold
Plate ideally using both
1/4” and 3/8” BSW
fixing screws.
The gold plate can be
used to mount the Master
Series Hood and the
Professional Series
Hoods. The professional
series hood is used
throughout this guide.
Master Series Hood
