
User Manual
Index
Parts Overview .............................................................. 3
Standard Accessories .................................................... 4
Operation Instructions .................................................. 4
Figure 1: Gear Axle ........................................................ 5
Figure 2: Initiative Axle .................................................. 6
Figure 3: Fork .................................................................7
Figure 4: Change Speed Axle ........................................ 8
Figure 5: Turning Plate and Mixing Axle ....................... 9
Figure 6: Single Phase Motor Diagram ....................... 10
Figure 7: Center Axle ................................................... 11
Maintenance and Protection ........................................ 12
Troubleshooting ........................................................... 13
Warranty Information ................................................... 13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
Cleaning ........................................................... 13
Troubleshooting
User Manual
www.AvantcoEquipment.com 13
Troubleshooting
Trouble Possible Causes Solution
The axles can’t work when
operating the machine
Poor contact of the electrical
equipment
Check the Plug
The mixing bowl is out of position Moving direction is not correct Change
Leaks oil Sealing washer is damaged Change
Clean the slideway andlubricate
The motor is overheated
and speed is down
The voltage is not enough, or
incorrectspeed
Check the voltage or use
lowerspeed
Noise and overheating Poorlubrication Add or changelubrication
Mixer touches bowl The mixing device or bowl de -
formed
Repair or change the bowl
or mixing device
Limited Warranty
Cleaning
before changing speed in order to avoid damage to the gear bo
DISCONNECT THEMACHINEFROM THE POWERSOURCEBEFORECLEANING.
!
All new mixer bowls and accessories including, whips, beaters and dough hooks should be properly washed before use.
n with
clean water. It is highly recommended this cleaning procedure is followed for bowls and accessories prior to whipping egg whites or
whole eggs. The mixer should be cleaned daily with a clean damp cloth.
If the unit has not been used for some time it is recommended that the procedure above is followed before mixer use.
It is important that the rear bowl lift guides are greased every three months to prevent corrosion.
WARNING:
WWW.AvantcoEquipment.com 10
Royal-Kincool Refrigeration Equipment Co., Ltd
Juice dispenser model: Corolla series, English manual
Released date: 2005.10.27
Connecting to a fresh life
No power to
machine
Insert plug into mains socket
Main switch is not on the “I”
position.
Switch main switch to “I” position.
Ask for
authorized
service
department
to check and
repair it.
Machine is
not cooling
Compressor does not start
See “compressor does not start”
section.
Gas leak into the cooling
circuit.
Find leak, filter it out and re-charge
the cooling circuit
Increase distance between the
machine and other obstacles /
heating sources
Compressor
does not
start
Ask for
authorized
service
department
to check and
repair it.
Compressor protector is
broken.
Replace compressor protector
Compressor relay is broken
Compressor motor is broken
One tank is
not cooling
Gas leak into the cooling
circuit
Find leak, filter it out and re-charge
the cooling circuit
Increase distance between the
machine and other obstacles /
Tube of the cooling circuit is
clogged.
Cut the tube, eliminate clog,
re-charge the cooling circuit
paddles are
The mixing motor is broken
The pump motor is broken
The pump switch is broken.
Warning: If the appliance has any problem or has been damaged, do not try to repair or
replace it by yourself. Please ask for the authorized service department for help.
Manufacturer: Royal-
Trouble Possible causes Solution
All equipment, which is sold under the Avantco trademark and used for commercial purpose is
warranted against defects in materials and workmanship. The warranty runs for six months from the
date of original installation and is for the benefit of the original purchaser only. All other warranties,
expressed or implied, Statutory or otherwise, including without limitation any implied warranty of
merchantability or fitness for purpose are excluded. The seller shall in no event be liable for direct or
consequential damages in connection with Avantco commercial products.
This warranty is not effective if damage occurs because of accident, carelessness, improper
installation, lack of proper set-up, supervision when required or if the equipment is installed or
operated in any manner contrary to the installation and operating instructions. In these cases, repairs
will be made at a reasonable cost. Work performed by unauthorized personnel or unauthorized
service agencies voids warranty. Residential Use voids warranty.
This warranty does not apply to, and Avantco is not responsible for, any warranty claims on products
sold or used outside of the United States.