Avantco Equipment 177CMAPADJ User manual

User Manual
www.AvantcoEquipment.com 1
User Manual
Automatic Coffee Makers
Models: 177CMA1B, 177CMA2B, 177CMA1L2U,
177CMA3L, 177CMAPADJ
Please read and keep these instructions. Indoor use only.
2/2023
89GF

User Manual
2 www.AvantcoEquipment.com
Important Safety Informaon�������������������������������������������������������������� 3
Installaon ������������������������������������������������������������������������������������������ 4
Operaon�������������������������������������������������������������������������������������������� 5
Cleaning ���������������������������������������������������������������������������������������������� 6
Decanter Brewers Parts Diagrams & List������������������������������������������7-10
177CMAPADJ Parts Diagram & List ������������������������������������������������ 11-12
Equipment Limited Warranty������������������������������������������������������������� 13
Index

User Manual
www.AvantcoEquipment.com 3
Important Safety Information
• This appliance is designed for commercial use only.
• This appliance must be placed on a level surface able to adequtely support its weight.
• Users should not leave the appliance unattended while it is in operation.
• Never immerse the appliance in water.
• Do not unplug the appliance if your hands are wet.
• Do not unplug the appliance by pulling the cord.
• Do not attempt to repair or replace the power cord if it becomes damaged. Contact a qualified
service agent.
• While the appliance is in use, some parts will become very hot. Ensure that the cord does not
come in contact with any hot parts.
• Be careful not to touch any hot surfaces.
• Do not allow empty decanters to sit on the hot plate.
• Do not plug in or energize this appliance until installation directions are read and followed.
• Be careful not to touch any hot surfaces. Hot surfaces include, but are not limited to, burners,
appliance surfaces, brew chamber, and servers.
• Ensure all operators of the appliance are familiar with all instructions and warnings.
• Brewer must be properly grounded to avoid shock hazard.
• Use appliance only for intended purpose.
• Please keep this manual with appliance.
177CMA1B 177CMA2B 177CMA1L2U 177CMA3L 177CMAPADJ
Warmers 1 2 3 3 --
Server decanter decanter decanter decanter airport
Voltage 120V 120V 120V 120V 120V
Waage 1550W 1650W 1650W 1650W 1450W

User Manual
4 www.AvantcoEquipment.com
Installation
As stated in the warranty, poor water quality will void warranty. Whenever
installing new plumbed in equipment, water should be tested and new
water filtration catridge/system installed by a certified technician. Avantco
recommends item 790OCLOKITL from C Pure
1. Position the brewer on a sturdy, level surface.
2. Connect the brewer to a water source with a water
pressure between 20 and 90 psi using a ½” connection.
3. Plug the brewer into a power source with the correct
voltage.
4. Place empty glass decanter or airpot under the funnel.
5. Turn the brewer on and press the brew button.
6. The filling indicator will light up.
7. Hot water should start to flow into the pot after
approximately 30 seconds.
8. Repeat steps 4-7 twice to clean the internal parts of
the brewer before brewing coffee for the first time.
#790OCLOKITL
C Pure Oceanloch-L Water Filtration
System - 1 Micron Rating and 1.67 GPM

User Manual
www.AvantcoEquipment.com 5
Operation
Controls
1. Power Switch – Controls power to the entire brewer
2. Brew Button – Begins brew cycle with one push (177CMAPADJ offers two brew settings)
3. Filling Indicator Light – Shows that the tank is filling with water
4. Heating Indicator Light – Shows the water is heating in preparation to begin brew cycle
5. Warmer Switches – Each switch controls 1 warmer. On/Off setting
Decanter Brewers
1. Remove the funnel and insert a paper coffee filter.
2. Add the appropriate amount of coffee grounds and level across filter. Return the funnel to its correct position.
3. Make sure the empty decanter is positioned correctly under the funnel.
4. Turn the power switch on.
5. Press the Brew button.
6. Coffee will start to flow into the pot in approximately 30 seconds.
7. When the Heating indicator turns off, the brew cycle has completed.
8. Do not remove the server until the coffee stops flowing.
9. Dispose of used coffee grounds and filter.
10. Rinse the funnel.
11. To brew a second batch wait until filling and heating lights are off and restart from step 1.
Airpot Brewer – 177CMAPADJ
1. Remove the funnel and insert a paper coffee filter.
2. Add the appropriate amount of coffee grounds and level across filter. Return the funnel to its correct position.
3. Make sure the empty airpot or server is positioned correctly under the funnel.
4. Turn the power switch on.
5. Press the brew switch to the desired batch size.
6. Coffee will start to flow into the pot in approximately 30 seconds.
7. When the Heating indicator turns off, the brew cycle has completed.
8. Do not remove the server until the coffee stops flowing.
9. Dispose of used coffee grounds and filter.
10. Rinse the funnel.
11. To brew a second batch wait until filling and heating lights are off and restart from step 1.
Using Pour-over Mode (All models)
1. Follow above steps 1-4 (Do not press the brew button or toggle the brew switch).
2. Fill pour-over basin with appropriate amount of water.
3. Water from the basin will displace the same amount of water from the heated tank. The hot water will go into
the brew head and spray over the grounds. Coffee will begin to brew into the below container.
4. When the flow and dripping stops, the coffee is ready to serve.
5. Follow steps 9-11.

User Manual
6 www.AvantcoEquipment.com
Cleaning
Regular cleaning ensures long life. For dirt or smudges on the brewer’s exterior, a damp cloth will suffice. If necessary,
a non-corrosive, non-abrasive detergent or cleaner may be used. Be sure to unplug the appliance before cleaning.
Check and clean the sprayhead ensuring the holes remain open to provide optimal brewing.
Directions for Cleaning Glass Decanters
Use daily for best results
1. Shake bottle. Apply 3-4 squirts (approx. 1/4 oz. per 1 gal. of liquid) of Klearly Koffee into the decanters
(not included). Add very hot water (not boiling).
2. Use a carafe brush for best results on tough stains.
3. Empty solution and rinse vessel thoroughly with clean, warm water. Air dry or wipe clean before next use.
The Importance of Deliming
To prolong your coffee brewer’s life and maintain a consistent, quality product, regular deliming is recommended.
When hard water is heated, minerals are left behind which can inhibit optimum performance. You should perform the
following deliming process at least every 6 months. If your water is extremely hard, monthly deliming is recommended.
KlearlyKlearly
KoeeKoee
KlearlyKlearly
KoeeKoee
Klearly Koffee is a simple, easy-to-use product that should be used daily to
remove or prevent oil residue and mineral build-up, which turns rancid, causing
bitter tasting coffee or tea.
This deliming spring fits into the sprayhead opening of pour-over coffee
makers to loosen lime deposits. Made of stainless steel. Sold separately.
20” Deliming Spring
Deliming Procedure
• Mix 10 oz. of fresh or condensed lemon juice with 32 oz. of water and pour it into the water reservoir.
• Make sure an empty decanter is underneath the funnel, and turn the unit “ON” as if you are brewing a pot of coffee.
• If the brewer has stopped working, the use of a deliming spring (sold separately) may be necessary to loosen lime
deposits in the spray head.
• After the brewer has completed its cycle, turn it “OFF” and empty the decanter.
• Run two or three brewing cycles of plain water through the machine to rinse out all traces of the lemon water solution
before brewing more coffee.
If the brewer suddenly stops working during a normal brewing cycle, deliming may be necessary.

User Manual
www.AvantcoEquipment.com 7
177CMA1B Parts Diagram

User Manual
8 www.AvantcoEquipment.com
177CMA2B Parts Diagram

User Manual
www.AvantcoEquipment.com 9
177CMA1L2U Parts Diagram

User Manual
10 www.AvantcoEquipment.com
Decanter Brewers Spare Parts List
# DESCRIPTION VENDOR #
1Foot NUB001
2Boom Cover NUB002
3Base Frame NUB003
5Relay NUB005
6Relay Holder NUB006
7Wire Clip NUB007
8Power Cord + Plug NUB008
11 Inow Pipe NUB011
12 Boiler Tank NUB012
14 Main Heater NUB014
15 Sealing Ring Of Boiler NUB015
16 Lid Of Boiler Tank NUB016
17 Oulow Pipe NUB017
18 Auto Thermostat NUB018
19 Manual Thermostat NUB019
21 Fever Paron NUB021
22 Mica Warming Plate Holder NUB022A
23 Mica Warming Plate NUB023A
24 Warming Plate NUB024
28 Lid Of Water Reservoir NUB028
29 Net Of Water Entrance NUB029
31 Upper Cover NUB031
32 Waterproof Panel NUB032
# DESCRIPTION VENDOR #
34 Water Reservoir NUB034
36 Indicator (Red) NUB036A
36 Indicator (Green) NUB036B
37 Upper Frame NUB037
38 Screw of Sprinkler NUB038
39 Sealing Ring of Sprinkler NUB039
40 Sprinkler Holder NUB040
41 Sprinkler NUB041
42 Power Switch Single NUB042A
45 Body Frame NUB045
46 Rear Cover NUB046
47 SS Filter Bowl NUB047
48 Filter Supporter of Filter Bowl NUB048
49 Upper Panel NUB049
50 Lower Panel NUB050
51 Solenoid Valve NUB051
52 Solenoid Fixer NUB052
53 Level Switch NUB053
54 Elbow in Tank NUB054
55 Inow Pipe NUB055
57 Push Switch NUB057
58 Solenoid Valve Holder NUB058
59 Double Float Switch NUB059

User Manual
www.AvantcoEquipment.com 11
177CMAPADJ Parts Diagram

User Manual
12 www.AvantcoEquipment.com
177CMAPADJ Spare Parts List
# DESCRIPTION VENDOR #
1Foot NUB001
2Boom Cover NUB002
3Base Frame NUB003
5Relay NUB005
6Relay Holder NUB006
7Wire Clip NUB007
8Power Cord + Plug NUB008
11 Inow Pipe 10x15x300mm NUB011
12 Boiler Tank NUB012
14 Main Heater NUB014
15 Sealing Ring Of Boiler NUB015
16 Lid Of Boiler Tank NUB016
17 Oulow Pipe 10x15x375mm NUB017
18 Auto Thermostat 105°C NUB018
19 Manual Thermostat 145°C NUB019
28 Plasc Lid of Water Reservoir NUB028
29 Net Of Water Entrance NUB029
31 Upper Cover NUB031
32 Waterproof Panel (SS) NUB032
34 Plasc Water Reservoir NUB034
36 Indicator (Red) NUB036A
36 Indicator (Green) NUB036B
# DESCRIPTION VENDOR #
37 Upper Frame NUB037
39 Sealing Ring of Sprinkler NUB039
40 Sprinkler Holder NUB040
41 Sprinkler NUB041
42 Power Switch Single (black) NUB042A
45 Body Frame NUB045
46 Rear Cover NUB046
47 Filter Pan NUB047
48 Spring NUB048
49 Upper Panel NUB049
51 Solenoid Valve NUB051
52 Solenoid Fixer NUB052
53 Level Switch 2.2L/2.5L/2.6L NUB053
54 Elbow in Tank 10x40x40mm NUB054
55 Solenoid Inow Pipe 10x15x330 NUB055
56 Shi Switch of Capacity NUB056
57 Push Switch NUB057
58 Solenoid Valve Holder NUB058
59 Float Switch NUB059
60 Elbow-out NUB060
62 Sprinkler Cover NUB062