AVer COMSVCMNT User manual

CAMERA WALL MOUNT INSTALLATION GUIDE
1. Paste the drilling paper on the wall and
drill the holes for installing mount plate.
2. Secure the mount plate with screws on the wall. The mount
plate has two ways of installation as figure shown.
[Note] The screws are not inculded.
3. Asssemble the two mount plates and make sure
the two mount plates are jammed. Next, secure
two mount plates with screws.
4. Install the nuts on the screws.
5. For SVC series camera, paste the sponge to
the specified position as figure shown.
[Note] PTC seriec camera skip this step to step 6.
6. Secure the screw to the bottom of camera.
DO NOT serew tight, leave some spece
for sliding to mount bracket
1
2
1
2

PN:300AV2B1-D9W©2017 AVer Information Inc. All Rights Reserved.
6. Slide the camera into the mount bracket.
Don’t slide camera in the end, before
installing the cables to the camera.
8. Secure the camera on the mount bracket. First,screw tight the lower screw, then, screw tight the upper
screw.
9. Complete.
[Note] The PTC series camera doesn’t support to mount in upside dowon position.
7. Connect the necessary cables to the
camera. Then, slide the camera in the end.
1
2
1
2
1
2
SVC series PTC series
SVC series PTC series