axelbloom BEDS Austroflex Savia User manual

Assembly Instructions:
Austroflex Savia Bed Frame
A. Lay headboard flat on the floor, brackets facing up.
(fig. 1)
B. Make sure the small silver screws are screwed into
the headboard (these are what the side boards attach to).
There are four screws in total.
C. Attach the side boards to the headboard (fig. 2):
Make sure the arrows on the circular metal fasteners• are lined up with the bolts in the headboard. If arrows
are not lined up, sideboards will be prevented from
attaching.
Using the provided large silver allen wrench, turn the• circular fasteners clockwise until they are secure.
TIPS BEFORE STARTING:
1. We recommend that two people help you to assemble the bed.
2. Please open all boxes and compare the bed frame components with the pictures in this document
before starting to assemble the bed.
3. If you are uncertain at all, please call us. Office (toll free): 866-696-8387 After Hours: 310-339-1222
(with headboard)
fig. 1
fig. 2
Au
1

E. Carefully lift bed frame and lay flat on the ground.
F. Affix foot board to side boards using metal corner braces. Do not fully tighten screws until all
are partially screwed in. (fig. 3 & 4)
fig. 3 fig. 4
2

G. Raise bed frame so that head board is again laying on its back. (fig. 5)
H. Use long gold screws to affix metal feet to all four corners of frame.
(fig. 6 & 7)
*TIP: Be sure to line up feet flush to the inside corners of the frame.
fig. 5 fig. 6
fig. 7
3

I. Lay frame back onto floor, and affix center beam at desired height. (fig. 8) (See attached sheet
for center beam assembly instructions)
J. Attach L-shaped metal brackets (4 total) to metal face plates on side boards, making certain to
clip them on at the same height as the center beam. (fig. 8)
*TIP: you may need to lightly tap the top edge of L-shaped brackets with a hammer to fully
secure them to the face plates.
K. You may now place the bed suspension bases onto the centerbeam and L-shaped brackets,
followed by the mattresses.
TIP: There should be no squeaks when you rest on the bed. If the bed squeaks, simply rotate the
bottom of the plastic centerbeam foot to adjust it up or down until the bed suspension base rests
completely flat on the centerbeam. Check that each corner of the bed suspension is resting flat
on its support. (In order to access the centerbeam foot, you will need to remove the mattress and
bed suspension base from one half of the bed.)
4
fig. 8