Axelent Safe-X 400-22L User manual

Bike rack assembly
1
3
4
5
6
2
Step1, Assemble lower rear beam
Parts
2x “171206” (side)
1x “171212” (lower rear horizontal beam)
4x Bolt M10 x 70 mm
4x M10 nut
1:1, Assemble the parts
1:2, Attach the nuts loosely by hand
1:1 1:2
400-22L
6 - 1 6 - 2
AXELENT SAFE-X AB · BOX 1 · KÄVSJÖVÄGEN 17 · SE-335 04 HILLERSTORP, SWEDEN
TEL: [phone] · [email protected] · WWW.AXELENTSAFEX.SE

Step2, Assemble lower front beam
Parts
Parts from step 1
1x “171211” (lower front horizontal beam)
4x Bolt M10 x 70 mm
4x M10 nut
2:1, Assemble the parts
2:2, Attach the nuts loosely by hand
2:1
4:1 4:2
5:1 5:2 5:3
3:1 3:2 3:3
2:2
Step4, Assemble the lower rails
Parts
Parts from step 3
2x “20011” (fixed rail)
8x Bolt M10 x 70 mm
8x M10 nut
4:1, Assemble the parts
4:2, Attach the nuts loosely by hand
Step5, Put the bike rack on its side and tighten all the nuts
Parts
Parts from step 4
5:1, Put the bike rack on its side
5:2, Tighten all the nuts
5:3, Set the bike rack upright again
6 - 3 6 - 4
2
Step3, Assemble upper beam
Parts
Parts from step 2
1x “20152”(upper horizontal beam)
4x Bolt M10 x 110 mm
4x M10 nut
3:1, Assemble the parts
3:2, Check that the upper beam is tilting “backwards” (2° )
3:3, Attach the nuts loosely by hand
AXELENT SAFE-X AB · BOX 1 · KÄVSJÖVÄGEN 17 · SE-335 04 HILLERSTORP, SWEDEN
TEL: [phone] · [email protected] · WWW.AXELENTSAFEX.SE

7:1 7:2 7:3
Step7, Assemble the upper rails
Parts
Parts from step 6
2x “171054-20022 TMI” (extendable rail)
6x Bolt M10 x 110 mm
6x M10 nut
7:1-7:2, Assemble the parts
7:3, Tighten the nuts
7:4, Tighten all the nuts
Step6, Bolt the bike rack to the floor
Parts
Complete bike rack
at least 6x bolt, depending on the floor
material
Done!
6 - 5 6 - 6
AXELENT SAFE-X AB · BOX 1 · KÄVSJÖVÄGEN 17 · SE-335 04 HILLERSTORP, SWEDEN
TEL: [phone] · [email protected] · WWW.AXELENTSAFEX.SE