Axis 1114-1 Parts list manual

1
Axis 1114-1 Chainstitch Embroidery Machine
Assembly and Usage Guide
If you are facing an operation problem, please describe your
situation via our contact info below! Thank you!
Let Us Assist You!
● Email:[email protected]
● Video Call
● Whatsapp: [phone]
● WeChat : Tomsewing
● Service time: Mon. - Sun.8:00 – 20:00 UTC+8

2
Assembly and Adjustment
Step 1:
Install the metal hinge using hardware provided

3
Step 2:
Install the handle crank using the hardware provided.
The screw of needle bar holder and needle hook and handle
crank should be in the “6 clock direction”, or facing user. This
is an important step to properly setting up the machine! See
pictures on next page below for reference!
Picture below displays where to unscrew to adjust position of
needle hook.

4
Picture bellows showing needle hook in 6 o clock position
(facing same direction as handle crank)

5
Step 3:
When setting up the machine handle wheel, it should run
clockwise! Belt should run smoothly with no obstructions! Tighten
belt until it is secure, but do not over tighten! If belt is too loose,
adjustments can be made to reach ideal setting.

6
During operation, If the handle crank is pushed up, the stop motion
rocker will be holding its place. Pulling down the handle crank and
pressing foot pedal will allow you to begin stitching!

7
Picture below shows the stop motion rocker when it is pushed
up/not ready to stitch. Get comfortable pulling and pushing handle
crank, while looking at the inside of the machine to get a better
understanding! And always keep your machine well oiled!

8
As shown below, with the handle crank pulled down, The Stop
Motion will be released and machine will be ready to stitch!
Pushing down on your foot pedal will begin stitching

9
Pictured below, you can see stop motion rocker pulled down and
ready to stitch!

10