AzureWave AW-CU474-UNO User manual

1
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
AW-CU474-UNO
Arduino UNO Adaptor for AICM
User Guide
Rev. 0.1
(For Standard)

2
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
Revision History
Version
Revision Date
Description
Initials
Approved
0.1
2021/01/18
Initial version
Steven Jian
Chihhao Liao

3
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
Table of Contents
1. Hardware Specification.......................................................................................................4
2. Hardware Setup ...................................................................................................................5
3. Block Diagram and Schematic ...........................................................................................6
3.1 Block Diagram for AW-CU474-UNO........................................................................................................6
3.2 Schematics for Arduino Uno Adaptor ....................................................................................................7

4
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
1. Hardware Specification
Top side
Bottom side
PCB Antenna
8*2 female header for mounting AICM
SPI Flash
Two 8*1, one 6*1 and one
10*1 male headers bridged
to Arduino UNO

5
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
2. Hardware Setup
Remove all the jumpers (2mm pitch) on the dongle (AW-CU300AV3-USB orAW-CU427-USB)
before mating it with the Arduino Uno through AW-CU474-UNO. The digital logic level &
power supply input of the dongle are 3.3V. DO NOT directly connect the dongle to the
Arduino Uno.
AW-CU300AV3-USB orAW-CU427-USB connected to Arduino Uno through AW-CU427-
UNO
AW-CU300AV3-USB
or AW-CU427-uSB
AW-CU474-UNO
Arduino Uno

6
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
3. Block Diagram and Schematic
3.1 Block Diagram for AW-CU474-UNO

7
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
3.2 Schematics for Arduino Uno Adaptor

8
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.