Baby Lock Altair BLTA Installation guide

Baby Lock
BLTA Altair
Technical Training Manual

Altair Control Setting Pages
A Refresh Tab has
been added to each
Setting page to reset
the default for that
page.
If the Width Control
is on, the Foot
Control must be
used.
1

Altair Control Setting Pages
A change to the Free
Motion Foot Height
position could have a
an effect on the
stitching. There should
be little space between
the foot and the fabric.
If Needle Position is
set to stop with needle
up, the customer will
not be able to activate
‘ Pivot Feature ‘
If Stitch Placement is
on, the customer will
not be able to activate
‘Edge Guide Sewing’
Feature.
2

Altair Control Setting Pages
SCS Should be reset
to ‘0’ in the test
mode after servicing.
The machine should
be updated to the
latest Version.
Please document
the stitch count on
the customers
paperwork, as you
will delete it in test
mode.
3

Altair Control Setting Pages
Embroidery Tension
is to change the
overall default
setting for the upper
thread tension
during Embroidery.
A change in the
Embroidery Foot
Height, could effect
the stitching during
embroidery.
4

Altair Control Setting Pages
5

BLTA Disassembly
Top Cover
Remove the
lid by raising
straight up
6

Face Plate
A
Remove the
Screw
covers ‘A’
Remove 2
screws ‘B’
and slide
cover to left
B
7

Free Arm Cover
Detach Needle Plate Cover Detach Free Arm Cover
8