BaBylissMEN Crewcut 7758U User manual

Model 7758U
THE CREWCUT

SAFETY CAUTIONS
• This appliance should only be used as described within this
instruction book. Please retain for reference.
IMPORTANT CHILD SAFETY
WARNING! Polythene bags over the product or packaging
may be dangerous. To avoid danger of suffocation, keep away
from babies and children. These bags are not toys.
IMPORTANT SAFETY
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable signs
of damage. Do not use if damaged or if the appliance has
been dropped. In the event of damage contact the Conair
Customer Care Line (refer to UK After Sales Service section
for further information).
• Only use the attachments supplied with this appliance.
• Do not leave the appliance unattended when switched on.
• Do not place the appliance on any surface whilst in operation.
• Special care is required when using the appliance close to
the ears, eyes and face.
• This appliance should not be used by adults whose reduced
physical, sensory or mental capabilities, or whose lack of
experience and knowledge, might cause a hazard, unless
they have been correctly instructed to understand the safe
use and hazards involved and are adequately supervised.
• Careful adult supervision is required when this appliance is
used on or near children. Do not use on very young children.
• This appliance should not be used, cleaned or maintained by
children. Keep out of reach of children.

• Always ensure that this appliance is kept out of the reach
of children at all times, particularly during use and whilst
cooling.
• Allow the appliance to cool before storing away.
• This product contains batteries (Lithium-ion battery) that are
not to be removed from the appliance for charging.
• The batteries in this appliance are non-replaceable by the
end user. Only an authorised engineer should perform this
task for safety reasons.
• The supply terminals are not to be short circuited.
• For indoor, household, domestic use only.
• For the purposes of recharging the battery, only use the
detachable charging supply unit provided with this appliance.
• This product complies fully with all appropriate EU and UK
Legislation and the standards relevant to this type and class
of appliance. We are an ISO9001:2015 credited company
that continually evaluates our Quality Management System
performance. If you have any queries regarding product
safety and compliance, please contact the Conair Customer
Care Line (refer to «UK After Sales Service» section).
• The battery should be removed for safe disposal at the end
of its life.
• When the battery has run down, it should be disposed of at a
recycling centre to safeguard the environment. If the battery
leaks, avoid touching it and dispose of it at a recycling centre.

FEATURES
• Twin blade cutting system for multi-directional self-hair cutting
• Lithium ion technology for optimum performance and long lasting power
• 4 cutting comb guides; grades 1, 2, 3, 4
• Ear taper guide
• Cleaning Brush
• Oil
• Storage pouch
INSTRUCTIONS FOR USE
Charging Instructions
IMPORTANT! The Crewcut is very easy to use, however it is essential
that you fully charge the unit for 3 hours before its rst use. This initial
supercharge ensures optimum power performance to give smooth fast
cutting every time. Maximum battery capacity will only be reached after
3 charging/discharging cycles. A full charge will provide approximately
75 minutes use. A 30 minute quick charge will provide approximately 15
minutes use.
• Before using for the rst time, the appliance should be fully charged
continuously for 3 hours. Maximum battery capacity will only be reached
after 3 charging and discharging cycles.
• Ensure the appliance is switched off.
• Insert the small plug on the charging adaptor into the socket on the back
of the appliance.
• Plug the charging unit into a suitable mains socket.
• The red charging indicator light on the power handle will ash when the
appliance is correctly connected to the mains. When it is fully charged,
indicator light will remain on.
• A full charge will supply enough power for approximately 75 minutes of
cordless use.
• A quick charge of 30 minutes will give 15 minutes use.
• When the appliance is about to run out of energy, the charging indicator
will ash to indicate that there is less than 15% battery capacity remaining.

WARNING! If the charging light suddenly starts to ash rapidly, the
appliance is faulty. If this does happen, please stop charging and remove
the adapter from the power source and contact our Customer Care Centre
for further advice.
Preserving the Batteries
• In order to maintain the optimum capacity of the rechargeable batteries,
the appliance should be fully discharged and then recharged for 3 hours
every 6 month approximately.
Comb Guides
This appliance is supplied with 4 comb guides:
Cutting Length Grade
0.5mm #0
3mm #1
6mm #2
9.5mm #3
13mm #4
• To attach a comb guide, ensure the appliance is switched off. Position
the comb guide over the blades and slide the sides into the slots either
side of the blades until it clicks (Fig. 1).
Fig. 1

• To remove the comb guide, place your ngers each side of the of the
comb guide and gently pull down and away from the unit (Fig. 2).
The appliance is also supplied with an ear taper guide. This can be used
above the ear to get a clean line.
Preparation for Use
• Always inspect the appliance for noticeable signs of damage. Do not use
if damaged.
• Always inspect the appliance before use to ensure the clipper blades are
free from hair, debris etc.
• Ensure the appliance is well oiled.
• Ensure the appliance is sufciently charged.
• For best performance, use on clean, dry hair that has been combed until
tangle-free.
• Prior to use always inspect the head for warts, moles, spots and broken
skin. Special care should be taken to avoid injury and cuts.
• Remove any head jewellery such as earrings and necklaces before use.
Please Note: The appliance should not be used for longer than 20 minutes
when operated from the mains.
WARNING! The clipper is for use only on the head. Never use the clipper
on the face or any other area of the body.
Clipping
• Attach the comb guide length of your choice. Grade 1 = 3mm, Grade 2 =
Fig. 2

6mm, Grade 3 = 9.5mm, Grade 4 = 13 mm.
• Switch on the clipper using the on/off sliding switch located on top of the
clipper. The blades will start to move and the green LED will illuminate.
• Starting at the nape of the neck, hold the clipper with the teeth of the
clipper pointing upwards and the comb guide at on the head. Slowly
move the clipper upwards, through the hair, and towards the front of the
head in a forward sweeping motion. Once at the front of the head, engage
the opposite blade in a backward sweeping motion to move from the front
of the head, back to the nape of the neck.
• Continue with this sweeping motion, running from the nape of the neck
to the front of the head until you reach an even length all over.
• To tidy longer hairs around the ears and neckline, simply remove the
comb guide and use the blade for neatening edges and shaping
sideburns.
• Only apply gentle pressure. Never force the clipper– if resistance is
experienced lift clipper away from the head, empty hair from the clipper
and resume clipping.
• If using on areas where there are folds of skin, ensure the skin is stretched
taught prior to cutting hair in this area.
• If you experience any discomfort stop using immediately.
• If you require a grade 0 cut, the clipper can be used without a comb
guide attached.
Please Note: When you rst being cutting your hair, you may notice that
some hair is being cut, while others are left long. This is perfectly normal,
especially if cutting slightly longer hair because hair grows in many different
directions. Continue cutting in a back and forth sweeping motion until all
the hair is cut to an even length.
Removing the blades
• The blades can be removed to aid cleaning.
• To remove the blades, hold the handle by two hands,place your two
thumbs underneath the blades and push the blades away from the
handle (Fig. 1).
• Gently blow away any hair trapped beneath the blades.
• The blades can be rinsed under the tap. After rinsing, the blades may
need to be oiled. See oiling instructions below.
• Be sure the blades are dry before reattaching to the clipper body.

• To reattach the blades, put the position rib of the blades into the slot on
clipper body (Fig. 2). Then hold the handle by two hands, and press
downward by two thumbs (FIG. 3). there is ticktack when attaching the
blades.
CLEANING & MAINTENANCE
To maintain optimum performance, the appliance should be cleaned after
each use:
• Remove the comb guide after use. Rinse the comb guide under running
water and dry thoroughly before storage or use.
• Never place the clipper under running water.
• After each use ensure hair is emptied from the blade area and use the
cleaning brush to clean thoroughly.
• It is highly recommended to apply a small amount of oil (provided) to the
blades before each use.
• Wipe the outside with a damp cloth and dry thoroughly before use or
storage.
BATTERY DISPOSAL
This appliance contains Li-ion batteries. To protect the environment this
appliance and its batteries must be disposed of safely. At the end of its life,
please take this appliance to a recycling centre, where the internal rechargeable
battery should be removed by a professional and recycled separately.
For more information about the recycling of electrical and battery operated
appliances please contact your local council ofce or your household waste
disposal service.
Fig I Fig II Fig III

For specic enquiries regarding the replacement of batteries in this product
please contact our Conair Customer Care Line – see “UK After Sales Service”
section.
UK GUARANTEE
The Conair Group Ltd, Unit 3, Waterfront Business Park,
Fleet GU51 3TW
This BaBylissMEN appliance is guaranteed for consumer use for 3 years
and is only valid within the United Kingdom.
This guarantee covers consumer use only i.e. defects occurring under
normal use within the home from date of purchase or date of delivery,
whichever is later.
If the product develops a fault due to defects in materials or manufacture
within 12 months from the date of purchase, to avoid delays and
unnecessary inconvenience, where possible please return the product to
the point of purchase for an exchange,
If the product develops a fault due to defects in materials or manufacture
after 12 months from the date of purchase, and within the guarantee
period, Conair UK After Sales Service will repair or replace the product.
Exclusions
This guarantee will no longer be valid meaning that The Conair Group Ltd
will not be liable to repair or replace your product where:
1.) The appliance has been used on a voltage supply other than that which
is marked on the product, or advised within this instruction booklet
2.) The appliance has been purchased from an unauthorised stockist*
3.) The appliance is used for professional / non domestic usage
4.) Repairs or alterations have been attempted by unauthorised persons
5.) The failure of the appliance is a direct result of misuse
6.) The failure is a result of not following the instructions for use
Fig III

This guarantee does not cover any cosmetic damage due to misuse of the
product nor any damage to persons or property that occurs because of
product misuse.
*unauthorised stockists include, but are not limited to online auction sites,
private sellers and those selling second hand goods, refurbished products
etc
Please contact the Conair Customer Care Line on 03705 133 191 (09:00 to
17:00 Monday to Friday) or e-mail [e-mail] for further information
on authorised stockists.
It is important to retain your proof of purchase. We recommend
attaching your receipt to this page.
Even where a refund may be applicable, no refund will be provided
without a valid receipt or proof of purchase, we will only be able to
offer a repair or replacement service. Please note this does not apply
if the product was purchased directly from The Conair Group Ltd.
Guarantees on replacement products run from the original purchase date
or date of delivery, whichever is later, and not from the date of replacement.
This guarantee is an additional benefit and does not affect your
statutory rights as a consumer.
If you have any queries regarding this guarantee please contact the Conair
Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday)
or e-mail [e-mail]

UK AFTER SALES SERVICE
For further advice on using the appliance, contact the Conair Customer
Care Line on 03705 133191 (09:00 to 17:00 Monday to Friday) or email
your enquiry to [e-mail].
If you should need to return your appliance to us please send it to the
following address:
Customer Care Centre
Conair Logistics
Unit 4
Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your name and address, together with a copy of proof of
purchase and details of the fault.
Please note this Instruction Booklet is not the guarantee.