BAGNODESIGN ZEPHYR User manual

ZEPHYR
CONCEALED 2OUTLET SHOWER MIXER
CONCEALED 3OUTLET SHOWER MIXER

Part Name
Buried wall box
Upper cover (with level)
M5*40 hexagon socket head cap screw
Panel assembly
Set screw
Plugs
Zinc alloy handle
M6*60 expansion screw assembly
4mm hex wrench
Install the proof board
Allen key (HEX=4)
HF005 horseshoe sleeve
This part customer self-matching
S.No Qty.
1
2
3
4
5
6
7
8
9
10
11
12
1
1
4
1
1
1
1
4
1
1
1
11
8
9
10 11 12
123 4 567

Preparation before installation
Drain tank 3
Drain tank 1 Water tank 2
HOT COLD
Recommended opening
size: Figure a is the length
and width of the hole,
Figure b shows the depth
from the bottom of the
hole to the finished wall.
Installing a wall box
Install the two function
boxes and install them
directly in the direction
shown.
2
To install a single-function
shower, hit a sink (outlet sink
3). To install a two-function
shower, use two outlets (outlet
1 and outlet 2). Install a three-
function shower, then play
three out of the sink (outlet
sink 1, sink 2, drain 3).

Secure the box to the wall with 4
expansion screws and tighten with the
wrench, and make sure the box is
parallel to the wall; observe the level on
the box, pay attention to whether the
box is installed horizontally; "" indicates
upwards in the figure
Connecting hot and cold inlet and
outlet pipes
Note: Before connecting, please
turn on the water source first,
rinse the impurities in the water
pipe, and then turn off the water
source after washing.
Level
Drain tank 1
HOT
Water tank 2
COLD
3

The effect of cement filling. .
Stick the tiles and the tiles
should match the edges of the
box. After the tile is finished,
wait for the panel to be
installed.
Sealed wall
After rinsing and ensuring that
there is no leakage inside, fill
the surrounding wall with
cement.
4

The tile plane is flush, the excess of the
buried wall box is cut off, and the glass
ring is coated on the entire circle of the
box and the wall.
Note: 1: Be sure to cut flat to ensure that
the panel can be tiled.
Face 2
Face 1
Adjustment screw
Adjustment joint
(10) Place the wall horizontally according to the position shown in the
figure, and confirm that the valve core is open (up to the highest
position). Turn the adjustment joint so that it coincides with the
surface 1, and rotate the adjustment screw to coincide with the
surface 2. Finally, tighten the hex nut clockwise with the HF005
horseshoe sleeve (12).
Mounting panel
To close the water source, first loosen the two
hex nuts counterclockwise with the HF005
horseshoe sleeve (12), then use the tool (11) to
unscrew the three screws (3) and remove the
upper cover (2).
5

Install the handle (7), use the tool (9) to install the parts (5), (6) on the handle in turn, and
make sure the handle is securely installed.
Mounting member (4) panel assembly as shown
6

The effect diagram after the installation is
completed is shown in the figure above.
7
INM-ZEP-412/413-CP-8-18