Baldwin Boxall C2CN Care2 User manual

C2CN Care2 Network Interface Fitting Details
The kit comprises of the C2CN Network Interface
card and three (green, yellow & red) RJ45 leads.
For full installation & commissioning details
refer to the Care2 Installation Manual.
Before attempting to fit this component ensure
the Mains Power and Battery Backup have been
disconnected.
1) Remove the 4 screws securing the Front
Panel.
2) Open the Control Panel door to view the
internal components.
3) Disconnect the black 0V connection from the
battery to isolate the 24V supply.
C2CN Care2
Network
Interface Card
Installation Instructions
B A L D W I N B O X L L
Wealden Industrial Estate
Jarvis Brook, Crowborough
East Sussex TN6 2JR
Tel [phone]
www.baldwinboxall.co.uk
B A L D W I N B O X L L
Fitting Instructions continued
4)
5)
6)
7)
C2CN Network Card.cdr
Issue 4 ECR 3223 05/06/17

C2CN Network Card.cdr
Issue 4 ECR 3223 05/06/17
Wealden Industrial Estate
Jarvis Brook, Crowborough
East Sussex TN6 2JR
Tel [phone]
www.baldwinboxall.co.uk
B A L D W I N B O X L L
Fitting Instructions continued
8)
Fire Panel Connections (Optional)
For BVOCCA control:
On PC1352 set P15 to N/O and set P16 to +24V
Delayed Call Connections (Optional)
and BVOCCA Settings
For Volt Free Contacts:
On PC1352 set P15 to N/O or N/C and set P16 to PARK
Connect to DELAYED CALL OUTPUT terminals shown below
9)
Important
Commissioning
Instructions:
Immediately after
installing the C2CN
Card and BEFORE
attempting ANY
configuration:
1) Clear Device
Assignments.
2) Set the correct
Network Address
using Front Panel
Controls.
3) Initiate the
“Device Detection”
Procedure.
Note: If the Network
Address is not set
during Installation
then Network
Comms may fail and
Faults may not be
reported correctly.
BVOCCA Module
Switched
+V
0V
Switched +V
0V
C2CN or
C2CFPE
Module