Ballard Designs WS989 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-13-2020 Page 1 of 4
PRODUCT NAME: Chloe Wall Rack
ITEM NUMBER: WS989
ASSEMBLED DIMENSIONS : 21”H x 43.75”W x 5” Deep
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN INDIA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 2
B 2
Qty. Hardware Included
Ltr.
C1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver, Level, Pencil,
Drill with 1/4” bit,
Painter’s Tape (optional)
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
Screws
Wall Anchors
Wall Rack (C) FRONT VIEW
BACK VIEW
Keyhole
Bracket
Keyhole
Bracket
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine installation location for Wall Rack (C) and pencil mark wall for each Keyhole Bracket
on back of Wall Rack. If possible, center one of the Keyholes over a Wall Stud and drive Screw (A) directly
into Stud (Fig. 1).
For Keyhole(s) located in open drywall (no Wall Stud present) use a Wall Anchor (B) with Screw. (Fig. 2)
Mark location.Drill small pilot hole with 1/4” bit.
Gently tap Anchor into pilot hole.
Add/tighten screw.
INSTALLING WALL ANCHORS
1
2
3
Fig 2.
WALL
STUD
Optimal support is provided when Wall Decor
is anchored directly into a Wall Stud.
Fig 1.
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
1Place a strip of Painter’s Tape over both Keyholes on back of item to be hung.
PAINTER’S TAPE
Use a Screwdriver or other pointed tool to punch a hole in tape at TOP of each Keyhole.
2
Use a Level and Pencil to mark wall at installation location.
3
How to Create a Template for Keyhole Brackets
TOP
OF KEYHOLE
Remove Tape from back of item, place on wall at level line and mark location of punches.
Remove Tape and follow instructions for creating holes and installing specific hardware.
4
PAINTER’S TAPE
P
A
I
N
T
E
R
’
S
T
A
P
E