Banzai AQUA BLAST MOTORIZED BUMPER BOAT User manual

Safety Information
WARNING!
To avoid the risk of serious injury or death;
• Intended for only children aged 5-10.
• Motorized Bumper Boat™ is intended to be used as
a toy and not as a personal flotation device.
• Do not hang on or stand on the Motorized Bumper
Boat™ when playing.
• Do not use a high-pressure pump to inflate.
• Do not use an electric air pump if water or moisture
is present. This may result in electric stock.
• The total weight limit for the Motorized Bumper
Boat™ is 100 lbs (45 kg), and it is designed to hold
one child.
• Use product in swimming pool only.
• Read all instructions before using the Motorized
Bumper Boat™.
• Do not shoot water blaster cannon directly at
person’s eyes or face.
• Never drive Motorized Bumper Boat™ over the
swimmers.
• Do not dive underneath Motorized Bumper Boat™.
• Stop using Motorized Bumper Boat™ if there is any
damage to the propeller safety cage.
• Disregard of and not following the instructions from
manual and warnings could result in injury or death,
especially for children.
• All inflatables are temperature sensitive, therefore
never unfold or inflate in temperatures below 50°F.
• Once inflated, make sure that the product does not
come in contact with stones, gravel or other sharp
objects, which could puncture the inflatable.
• To extend the life of the Motorized Bumper Boat™,
avoid any unnecessary overexposure to direct
sunlight. Excessive sun exposure may prevent
premature material fatigue and may cause leakage.
While every attempt is made to embody the highest
degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all
risk of injury resulting from use. All merchandise is
sold on this condition, which no representative of the
company can waive or change.
Once assembled according to the instructions
provided, confirm that this battery-operated toy is
fully functional before placing in the water.
This is not a lifesaving device. Do not leave a child
unattended while the device is in use.
Only to be used in water in which the child can
comfortably stand up.
For use in pools only and under adult supervision.
REPAIR PATCH INSTRUCTIONS
For your convenience, a repair patch has been
included to repair holes in the inflatable section.
Do not use the patch for holes or rips on the seam.
In the event of an accidental puncture, cut out a
suitably sized patch. Make sure you round the
corners of your repair patch to avoid peeling. Make
sure the area to be patched is clean and dry. Press
patch firmly over the puncture. Do not inflate for 20
minutes.
IMPORTANT SAFETY INSTRUCTIONS.
PLEASE READ AND SAVE THESE INSTRUCTIONS BEFORE SETUP AND USE.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
FOR AGES 5-10
ADULT SET UP IS REQUIRED.
1. Controller Unit With Water Blaster x 1
3. Propeller Unit x 1 4. Pipe Cover x 1
2. Inflatable Motorized Bumper Boat™ Body x 1
5. Repair Patch x 1
IIII
Parts and
are shipped
together and
must be
separated before
assembling this
item.
II
A
3
4
Press the
release latches
(A) and push
downward
while pulling up
part .
3
4
3 4
AQUA BLAST
MOTORIZED BUMPER BOATMOTORIZED BUMPER BOAT
TM
PLEASE RETAIN THIS INFORMATION
FOR FUTURE REFERENCE.
COLORS AND CONTENT MAY VARY.
CHANGHUANG ROAD,
CHANGPING, DONGGUAN, CHINA
ALL RIGHTS RESERVED
MADE IN CHINA
www.toysinquiry.com

BANZAI 3BANZAI 2
Safety Information
BATTERY WARNINGS!
• Only adults should replace batteries.
• Alkaline batteries recommended.
• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be recharged.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Remove batteries from the product before extended
storage.
• Batteries have to be placed by respecting the
polarity indicated on the toy and on the battery. An
incorrect location can either damage the toy, cause
leaks at the batteries level, or, to an extreme
degree, set the battery on fire or explode.
• Never throw batteries into fire, they could explode.
• Please keep this information for future reference.
4. 5.
Installing / Replacing Batteries
(Batteries not included)
1. Unscrew the top cover on the controller unit with a screwdriver as shown.
2. Take out the battery box.
3. Install 8 x 1.5V “D” (LR20) size batteries accordingly.
4. Place the battery box back inside the controller unit and screw on the top cover with a screwdriver.
5. To replace batteries, make sure to remove the Motorized Bumper Boat™ from the swimming pool, unlock the
controller unit from the Motorized Bumper Boat™ and repeat procedures 1 to 4.
NOTE: Never install or replace the batteries while the toy is still wet or in the pool.
Another Side
1. 2. 3.
BEFORE RETURNING TO STORE
PLEASE VISIT
THE CUSTOMER SERVICE WEBSITE
BELOW FOR IMMEDIATE ASSISTANCE
REGARDING QUESTIONS OR
PROBLEMS WITH THIS PRODUCT.
www.toysinquiry.com
OR
1-800-434-6178

5. When the Motorized Bumper Boat™ is partially inflated, fully insert the pipe cover from the top. Finish inflating
the air chambers.
6. NOTE: Fill inflatable with air until the inflatable is firm and solid. If any seam begins to strain, immediately stop
inflation and release air to reduce the pressure until all signs of stress on the inflatable are gone. DO NOT use
the item if there is straining at the seams. Use of an over inflated item can result in serious injury, paralysis or
death.
7. Insert the propeller unit into the pipe cover from underneath the Motorized Bumper Boat™. You will hear the
unit click into place when it is properly inserted.
8. Attach the controller unit to the top of the propeller pipe by aligning the connectors and pressing the unit down
until it clicks twice.
NOTE: If you do not hear 2 clicks, the controller unit is not properly attached to the propeller pipe.
For easier assembly, push at the positions shown.
2.
Setup Instructions
1. IParts 3and 4are shipped together and must be separated before assembling this item.
II Press the release latches (A) and push 3downward while pulling up part 4.
III Separate pipe cover from propeller pipe.
2. Fully assemble before using this toy in a pool. Do not use on pavement or other hard surfaces.
3. Roll out Motorized Bumper Boat™. Inspect for holes, tears or other damage.
4. Inflate the Motorized Bumper Boat™ with air until it is halfway full. See diagram for air chamber locations.
NOTE: For easy air inflation, use a manual air pump designed specifically for plastic inflatable items.
1.
7.
6.
8.
Setup Instructions
5.
4.
I
III
II
3
4
A
3.
BANZAI 4 BANZAI 5

How to play
1. Place the assembled Motorized Bumper Boat™ into the swimming pool.
2. Press and hold the right handle’s trigger to start the propeller; release it to stop.
3. Turn the controller unit for steering control.
4. To shoot the water blaster, hold down the trigger on the left handle.
5. IMPORTANT: To prevent overheating, the Motorized Bumper Boat™ may automatically shut down for cooling
after long continuous play. The cooling process may take up to 1.5 hours.
WARNING!
1. This is a toy and not a life saving flotation device. It should not be used as such.
2. Attention! Motorized Bumper Boat™ should be used in water level no higher than the neck of a standing
child and under adult supervision.
3. There should be a minimum of 6 ft (183 cm) between the product and the swimming pool wall to prevent the
possibility of the child falling off and hitting his head on the edge of the pool’s wall.
AUG.2016
4. 5.
2. 3.
Use Instructions
1.
1. Remove the Motorized Bumper Boat™ from the pool.
2. The controller unit by pressing the release button at the bottom.
3. Unlock the latches at the pipe cover and remove the propeller unit. Deflate the Motorized Bumper Boat™ and
let it dry thoroughly.
4. Remove all the batteries and drain away all the water in the propeller unit before storage.
NOTE: Always store the Motorized Bumper Boat™ in a dry place. Never leave in the pool or outside when not
in use.
5. When the Motorized Bumper Boat™ is completely dry, carefully fold it up and store in a secure location away
from children. Do not store indoors or in a closed container until it is completely dry.
NOTE: Store the Motorized Bumper Boat™ in a secure place, away from children, to prevent suffocation.
3.
2.
After Use & Storage
1.
4. 5.
BANZAI 6