airquee Enclosed Demolition Operating instructions

Page 1of 5
Thank you for purchasing the
Enclosed Demolition
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT YOUR
OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT. THIS MANUAL,
TOGETHER WITH THE SUPPLIED MAIN OPERATION MANUAL, MUST BE READ BEFORE
ATTEMPTING TO SETUP/USE THE PRODUCT.

Page 2of 5
Site Survey
1. Carry out a survey of the area where the Enclosed Demolition will be located, and check
for any overhead/underground cables. It’s important that this is carried out to avoid ground
anchors penetrating underground services, and the Enclosed Demolition coming into
contact with overhead cables when inflated.
2. You should provide an adequate power supply to the fan, this should adhere to your local
power regulations.
3. Check wind speed: It is not allowed to use an inflatable outdoors in a wind higher than
force 5 on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze
when small trees in leaf begin to sway.
Inclusions
You will need a suitable 230v/13Amp power supply to operate the fan.
CAUTION! Precautions should be taken during handling and use of
the product to prevent electric shock. The blower requires a Ground
Fault Protected Circuit (GFCI). Please read the manufacturer’s
Instruction Manual before using the blower(s).
Extra equipment you could consider for your new inflatable:
•Ground sheet to protect the underside of your inflatable
•Sandbag covers to anchor your inflatable indoors
•Sack truck to move your inflatable safely
•RCD to attach to your extension lead
•Crash mats.
•Fan cover box.
This inflatable can be set up and packed away by 3 persons who have
had proper manual handling training and use the correct equipment to
move the inflatable.
The Inflatable
In Its Bag
Gymnic Ball
Adult Helmets
Child Helmets
Neck Braces
Suspension
Straps
Anchor Pegs
Carabiner
Repair Kit
Polypropylene
Ropes
3x
3X
4X
4X
4X
Land Operation
Manual

Page 3of 5
Intended Use of the Product
The Enclosed Demolition is a game designed for 4 players. Each
player stands on its own podium and try to knock the other players
down with the help of the suspended inflated ball. The last player to
remain standing wins.
This is not a bouncy castle and should not be used for bouncing on.
Supervisory Personnel
The minimum number of supervisors required is 1.
Operating Guidelines/Rules of Play
Before entering the game area, CLEAR INSTRUCTIONS SHALL BE GIVEN to players on their
conduct during playtime.
- Always run a trial before allowing users on the play area.
- Do not use the product without the supplied safety inclusions. Neck braces and helmets
MUST BE WORN AT ALL TIMES.
- No one with ANY PRE-EXISTING INJURIES or HEALTH CONCERNS (limitations), in the
state of PREGNANCY or UNDER THE INFLUENCE OF PSYCHOTROPHIC SUBSTANCES
may use the unit.
- Do not allow users access to the pegs, fans, cables or zips.
- Check the fan, zips, anchor ropes and every other inclusion before, during and after every
use.
- Do not allow users to climb or sit on the walls.
- Do not allow users to hang from the inflatable ball.
- The inflatable to be used with the supplied fans only.
- Always respect the maximum number of users. Never allow anyone on the play area whilst
4 players are dueling.
- Do not leave the product unsupervised in an inflated state. When not in use, deflate it.
- No food or drink is permitted on the play area. Players may not have anything in their mouths
(gum, candy, etc.) while on the play area.
Setup
1. Before inflating the unit please tie the
suspension straps across the top beams and
connect them with the supplied carabiner.

Page 4of 5
2. After inflating the unit, you may inflate the ball with the help of the supplied hand held fan.
- Setup the fan to inflate using the correct connector, and connect it to the inflation/deflation
valve shown below. Then switch on the fan and start inflating the ball until it is firm to touch.
IMPORTANT: DO NOT LEAVE UNATTENDED WHEN INFLATING AND DO
NOT OVER INFLATE SINCE THE BALL HAS NO OVERPRESSURE VALVE.
- Remove the pump from the ball's valve and quickly insert the valve stopper.
3. The ball is attached to the webbing strap with two metal rings:
ENJOY AND HAVE FUN!
INFLATION VALVE
1.
2.
3.
VALVE PLUG

Page 5of 5
Legal Disclaimer:
The Airquee Additional Operating Instructions (the "Additional Manual") is proprietary to Airquee Ltd and no
ownership rights are hereby transferred. No part of the Manual shall be used, reproduced, translated, converted,
adapted, stored in a retrieval system, communicated or transmitted by any means, for any commercial purpose,
including without limitation, sale, resale, licence, rental or lease, without the prior express written consent of Airquee
Ltd.Airquee Ltd does not make any representations, warranties or guarantees, express or implied, as to the accuracy
or completeness of the Additional Manual. Users must be aware that updates and amendments will be made from time
to time to the Additional Manual. It is the user's responsibility to determine whether there have been any such updates
or amendments. Neither Airquee Ltd nor any of its directors, officers, employees or agents shall be liable in contract,
tort or in any other manner whatsoever to any person for any loss, damage, injury, liability, cost or expense of any
nature, including without limitation incidental, special, direct or consequential damages arising out of or in connection
with the use of the Additional Manual. All logos, images and content not owned by Airquee Ltd are copyright to their
respective owners and have been reproduced by permission.
Your product model, and its inclusions (number and type) may differ from the one presented in this manual. All the
pictures and drawings contained in this manual are for illustration purposes only. Any misuse or failure to adhere to the
instructions and recommendations contained in this manual will render void the warranty.
This additional manual to be sent only for AQ2011, AQ2480, AQ2587, AQ533 Version 1.1 03/10/2018