Barco BC1305 User manual

BC1305 REV# 1
BC1306
BC1307
BC1308
BENCH INSTRUCTIONS

BENCH END
ABC-SSI1020
X3
SEAT SLAT
X8
1/4" X 1.50" LAG SCREW
X24
F0002
REQUIRED TOOLS:
-(1) SCREW GUN
-(1) 7/16" SOCKET
-(1) 8" - 10" POST HOLE DIGGER
-(1) LEVEL
1/4" FLAT WASHER
X24
F0001
REQUIRED MATERIALS:
-READY-TO-MIX CONCRETE
-LOOSE GRAVEL
-WIRE & BRACING MATERIAL
BEFORE INSTALLING BENCH, PLEASE CHECK LOCAL CODES TO ENSURE PROPER
INSTALLATION. THESE INSTRUCTIONS ARE A GENERAL GUIDELINE ON HOW TO
INSTALL A BENCH. IF UNSURE ON HOW TO INSTALL, PLEASE CONTACT A
PROFESSIONAL.
BENCH INSTRUCTIONS
INCLUDED HARDWARE &
REQUIRED TOOLS FOR
ASSEMBLY
2/6

SEAT SLATS
SPACING DETAIL
T
F0002
F0001
PRE-DRILLED PILOT HOLE
(BACK VIEW)
V
1/8"
SPACING
1
KEEP SPACING BETWEEN BOARDS
APPROXIMATELY 1/8".
REPEAT STEPS FOR REMAINING SEAT
SLATS
BENCH INSTRUCTIONS
3/6

26.00 in
(8" - 10" DIAMETER)
30.00 in 30.00 in
4.00 in
LOOSE GRAVEL
2
USING POST HOLE DIGGER, DIG THREE HOLES AS SHOWN BELOW. THEN, FILL IN EACH HOLE WITH APPROXIMATELY 4" OF
LOOSE GRAVEL.
BEFORE INSTALLING BENCH, PLEASE CHECK LOCAL CODES TO ENSURE PROPER
INSTALLATION. THESE INSTRUCTIONS ARE A GENERAL GUIDELINE ON HOW TO
INSTALL A BENCH. IF UNSURE ON HOW TO INSTALL, PLEASE CONTACT A
PROFESSIONAL.
BENCH INSTRUCTIONS
4/6

17" - 18"
-CAREFULLY, PLACE THE BENCH INTO HOLES. CENTER EACH POST IN EACH HOLE AND LEVEL BENCH. ALSO, BE
SURE TO CHECK SEAT HEIGHT TO ENSURE COMFORTABLE SEATING. SECURE PLACEMENT OF BENCH WITH BRACING
MATERIALS AND FILL IN HOLES WITH READY-TO-MIX CONCRETE. ALLOW TO DRY AND REMOVE BRACING
MATERIALS.
3
BEFORE INSTALLING BENCH, PLEASE CHECK LOCAL CODES TO ENSURE PROPER
INSTALLATION. THESE INSTRUCTIONS ARE A GENERAL GUIDELINE ON HOW TO
INSTALL A BENCH. IF UNSURE ON HOW TO INSTALL, PLEASE CONTACT A
PROFESSIONAL.
BENCH INSTRUCTIONS
5/6

27.438 27.438
71.875
4.750
17.000
29
GROUND
10.750
1.500
14.375
3.500
9
30.976
19.382
CONSTRUCTION MATERIALS:
Recycled Plastic, Powder Coated Steel
HARDWARE:
Stainless Steel
SET POST 24 TO 26 INCHES INTO GROUND
ALL DIMENSIONS SHOWN IN INCHES
BC1305
BC1306
BC1307
BC1308
BENCH SPECIFICATIONS